Search results

  1. 9

    a9m probs now

    In theory the update only box should only update the items that where changed with uploading a new tune. I have read that this can and most of the time will corrupt the tune. It have had that happen to me within the week then read that the program Binary Editor (BE) is a better tuner and works...
  2. 9

    24 lb injectors?

    stanggt1995, i'm running a combo similar to yours. I have 24# injectors on my tweecer at WOT i'm around 12.5 - 12.7 A/F ratio, the percentage that my injectors are hitting are in the 90% range. meaning these are just about maxed out at WOT for 24#'ers. I really would think about upping the...
  3. 9

    a9m probs now

    Dude, swap to BE. I used CalEdit for a week and it messed my tune because of the update check box was checked a few times during upload. I almost didn't make it home yesterday. I swapped to BE and things are running much nicer...
  4. 9

    TwEEcer TB Air Flow question

    I forgot who I got this from, it was a person on Stangnet though. If you read through it, it states how to get the TB air flow. Thanks to the person that wrote it... • Adjust the idle screw on the Throttle Body (TB) all the way out allowing the throttle plate to fully close. Now turn the idle...
  5. 9

    Switch Tune?

    I just got the Tweecer RT and I have a possible 4 tunes, plus number 5 for bypassing and using the tune on the EEC. There's a small knob that came with mine for the swapping of tunes and I can change between tunes on the fly with engine running. (I HAVE DONE IT) :)
  6. 9

    1.6 vs 1.7 RR?

    I'm running higher than .550 lift on a stock 5.0 block, (out of an explorer) and i'm not hitting the pistons. My lift is around .577 that's with 1.7 rockers.
  7. 9

    Brakestand wheel hop - (Vid Soon)

    brakestand - put your heal on the brake and your toes on the gas. Use your toes to press the gas and keep your heel hard on the brakes. This leaves your left foot for the clutch. Get your feet ready in position, then push the clutch rev it up and dump the clutch in first. This should work for...
  8. 9

    plugs still white

    Dude, your running lean in either those cylinders or your are just plain running lean across the board. Check the injectors and clean them all out if that doesn't work go to the dyno and get it measured. I wouldn't really step on it still you get it fixed, running lean isn't a good thing..
  9. 9

    5.0 Programer

    You know what your right, it's is a contradiction, but at the time I really wasn't thinking that I was going to get a tuner. I thought that if I just got a maf that worked with my injectors that I would be fine. I have (slight) drivability issues it bucks every once in while during regular...
  10. 9

    Cam Install

    Always check the lift to ensure that your not going to hit. Chances are you won't i'm running a pretty high lift cam and i don't hit..
  11. 9

    5.0 Programer

    Friday I am ordering the Tweecer RT for my Mustang. I don't agree with the statement of just because the motor is lightly modded you don't need it tuned. I have looking into "Tuners" now for a while and looking at the things that can be changed and you need to change. The Stock settings...
  12. 9

    Stupid Question

    I got the white plastic clamps off, but the connections look like they are the same as the ones that go to the fuels rails with the injectors.
  13. 9

    Stupid Question

    What tool did you use to get the filter off? I desperatly need to change mine, but not sure the tools to change it with.
  14. 9

    solid motor mounts

    I got the solid mounts and only at idle does the car vibrate. While cruzing and such the car is fine, doesn't really vibrate any more than before.
  15. 9

    fuel pressure what to high or low??

    What makes you think it's running rich? If your smelling gas while you drive take the off-road pipe off and put cats back on. If what you listed is all you have then that's the reason. Your not running rich you just don't have any cats and that's what happens. Mine is the same way..
  16. 9

    going buy cobra R rims soon!

    How much are you paying for those? I have a set of polished ones I'm thinking about selling with tires. 17x9 4-lug cobra R's...
  17. 9

    Engine Diagnosis - Help!

    You have checked quite a bit of stuff, but according to your post have assumed quite a bit as well since the previous owner didn't know much about the car. I would check the following: Injectors 19, 24, 30 what size are they? Ensure that the MAF is "calibrated" for the injectors What do you...
  18. 9

    F-cam

    With this cam, power doesn't come on till about 3k RPM's. I used to have it, power is great after 3k rpms though.
  19. 9

    Bad fuel filter??

    Pull the codes and see what is happening. Even if there isn't a CEL there could still be codes to give a clue as to what is wrong. Define "really high" what mods have you done to the car, please list.. Thanks