Search results

  1. B

    Disc Brake Conversion ?

    They can work with manual brakes, but they're really intended to be used with power brakes. Dude, not to rain on your party, but for 100 bucks more you could've had power brakes and 13 inch rotors. On the other hand, it's your car. :nice:
  2. B

    Disc Brake Conversion ?

    All you have to do is have the rotor pressed. You can do it by tightening the lug nuts. It won't break, or take it to a machine shop.
  3. B

    roll bar

    A while back I saw a guy´s mustang site and he had pics of his 4 point roll bar installation in his 66 coupe. The roll bar was just like the one in the pic. He welded the roll bar to the floor pans, but cool thing was when he installed the rear tubes that weld to the wheel wells (red striped...
  4. B

    Disc Brake Conversion ?

    Try Mustang Steve´s disc conversion. He uses cobra 13 inch discs, and cobra calipers. You get to use your spindles and hubs (so no alignment needed), for $750. If you already have power brakes then you´re all set, but if your car does not have power brakes, he also sells a bolt in kit with...
  5. B

    What are the chances's?

    Shelby did not built notchbacks. The notchbacks Shelby souped up for racing were regular mustangs.
  6. B

    Help identifying '68-specific pedal assemblies.

    Why don´t you try a clutch cable instead of the z bar?
  7. B

    Help identifying '68-specific pedal assemblies.

    Here´s this out of my 68 FB, 4 speed, non-power brakes. Modified for clutch cable and bearings, but everything else untouched. http://img258.imageshack.us/img258/1581/dsc052364il.jpg http://img193.imageshack.us/img193/9500/dsc052379ms.jpg...
  8. B

    dangers of not using a pilot bearing

    Try wet newspaper instead of the grease, same result minus the mess. Pack the hole with the wet paper and hit the punch until it won´t go any deeper, take the punch out and pack more paper into the hole, repeat as needed until the sucker slides out.
  9. B

    Blue instrument panel lights PICS

    Take it apart and take some pics.....buddy ole pal.... :nice:
  10. B

    Solid Gas Cap

    This is a nice setup. http://www.terlinguaracingteam.com/index.mvc?Session_ID=&scr=viewimage&image=/gallery_trt_001/trt_001_trunk-L.jpg
  11. B

    how do I?

    Power or manual steering?
  12. B

    should i buy or not

    Don´t buy it, especially if you already have a 1990 GT, you will be very dissappointed with the 6 cyl. engine. Keep on looking you might find a better deal. My cousin´s neighbor sold his rust free 66 gt for $3000 when he lost his job.
  13. B

    How thick can I go with bondo?

    Get another door.
  14. B

    Should i add fiberglass restomod parts? eleanor/cali-spec?

    Since you´re asking......go for the California Special, you´ll never be wrong. E-whores are riced out mustangs.
  15. B

    i need help

    Age and driving record determine how much you pay. If you´re under 25, single, no kids, you´re a "high risk driver". The difference in premium for not having airbags, antilock brakes, etc, will only be minimal.
  16. B

    Pics of tail light "blackout" panel installed

    Looks Bad @$$. What´s it made of? aluminum or plastic? How much dinero?
  17. B

    Fuel line question

    Dirty or clogged fuel lines do not cause overheating or pingig. Check the timing, flush the radiator, change the thermostat, and use antifreeze. Also make sure the water pump is working as it should too. Once a water pump went bad on me because the propeller had completely rusted to dust but the...
  18. B

    How much for a 67 Fastback...

    I really doubt you'll get it for less than 4 grand, that's more or less what fastback shells are selling for, but then again, you never know. Good luck.
  19. B

    Been Scammed what should I do?!?!

    Cops won't do anything, just get your money back via pay pal and give him the worse negative feedback you can think of.
  20. B

    Rebuilt a steering box?

    Damn, less than three turns from lock to lock??? That´s pretty good, I think that´s the way I´m going to go. Thanks for the info Moneypit.
Top Bottom
Back
Forums
Menu