Search results

  1. H

    Mass air to Speed Density?

    So did you get any codes at all? Did you get code 11??
  2. H

    very off the wall question

    I remember seeing a pic with a leaf blower on a car. couldnt see much of the engine but it looked like a 4.6 couldnt find the one i was thinking of but heres one on a 5.0 lol
  3. H

    Is this an exhaust leak? Video inside...

    least im not alone in hearing 2 sounds lol sounds like a bad bearing to me as well. almost identical when my bearings in my alt. took a ****. but if the sound is still there when the belt is off the I dunno
  4. H

    Is this an exhaust leak? Video inside...

    I hear a high pitch noise when you rev it as well. not just the sputtering whine. probably just the sound i get from the video haha
  5. H

    Is this an exhaust leak? Video inside...

    I hear 2 sounds but kinda sounds like a bad pulley to me. If you take off the belt does it still make the sound
  6. H

    Mass air to Speed Density?

    I believe the stock mustang injectors are black and orange. is there any orange on them at all where the connect to the harness and fuel rails?? but you need to check and see if there is any codes and you can do it with a test lamp and jumper wire or paper clip. look at this link thanks...
  7. H

    Mass air to Speed Density?

    out of curiosity but when was the last time the PCV valve and screen were replaced?
  8. H

    Mass air to Speed Density?

    what codes did you get this time after installing the maf??
  9. H

    Fuel Pressure Not Keeping

    Im dealing with the same problem. Even with a brand new walbro pump and new FPR.
  10. H

    Mass air to Speed Density?

    you remove the negative if you are going to remove a cable. just like you always remove the NEG. cable 1st before removing the POS and always put the NEG cable on last
  11. H

    Belt squeeks after car starts up

    if you shoot the belt with WD40 does the sound stop? you may narrow down if its the belt or an pulley. Mine does it too when it has been sitting for a little and it goes away after it heats up(belt) a bit. really humid where I live and the belt gets really sticky try that
  12. H

    update 88lx5.0 no start

    check out this link http://www.stangnet.com/mustang-forums/787471-cranks-ok-but-no-start-checklist-fuel-injected-mustangs.html
  13. H

    Non working IAC motor

    I dont know whats going on with my IAC. My IAC doesnt seem to work sometimes. Some times when I drive and I stop at a light, the RPM's drop to where I have the Idle set with the IAC disconnected. but sometimes it doesnt. when I have this issue I disconnect the IAC when its idling and see...
  14. H

    Erratic squeeking from front suspension

    possible tie rod ends. had these issues. but lucky for me the previous owner replaced them with ones with grease fittings
  15. H

    Sticky stuff in connecter

    you can buy it in a can I believe and you can also buy it in a little .99 pack. depends on how often you will use it. May just benefit you to buy the .99 pack at the front counters of an auto parts store
  16. H

    New Misfire? Please help me, help her...

    I would take your TFI to like autozone and see if they can test it there. I know my local one does. Sounds like the issue I had and it was a bad TFI when it got Hot. If possible try to get the thing hot when they test it. I took it off in their parking lot before i had the tested when I...
  17. H

    new 5.0 crate motor question

    Whats the question?? lol
  18. H

    fuel pump help

    is that fuel pressure PSI with or without the vacuum connected to the FPR??
  19. H

    Throttle body gasket Help

    My buddy went through the same thing almost. He heated the metal around the intake with a torch and got it really hot and pried it apart. heated up the sealant enough for that to work he put a piece of metal down ontop of the intake/egr and hit that with the torch so he wouldnt burn the...
  20. H

    Mass air to Speed Density?

    I thought Id would ask cause if they didnt change the computer, he is running a SD car with a ecu for mass air. Im kinda curious what could or would happen if thats the case
Top Bottom
Back
Forums
Menu