Search results

  1. flstang65

    Ohv Motor In 04 Mustang?

    You will need a new k member, and stand along fuel system to say the least. Will probably need a tranny as well. it's been covered on here several times and I had a friend that did it. Long story short, for the money, time and effort, he wished he would have stayed with a 4.6. That would be my...
  2. flstang65

    Staggered Wheels, + Lowering

    305's in the rear and don't go too low
  3. flstang65

    Identify These Wheels

    Pretty much available anywhere.
  4. flstang65

    1996 Oil Pan R2

    I wouldn't worry about it, honestly.
  5. flstang65

    Engine Every Time My Car Is In Drive And I Press The Gas It Just Revs The Engine Like I'm In Neutral.

    Yup, rebuild or, replace.
  6. flstang65

    Fuel Pump?

    Keep a few laying around for the future!
  7. flstang65

    Engine Split Second Hesitation In 4.6l 98 Gt

    Coil pack or 2 would be my guess.
  8. flstang65

    Under Dash Phantom Heat

    Another thought, I notice on a lot of Mustangs that the accelerator pedal is close to the transmission tunnel and, over time, a hole can wear in the carpet and insulation letting more heat into the area.
  9. flstang65

    Drivetrain Clutch Noise

    Did you change the throw out bearing when the clutch was changed?
  10. flstang65

    Shell

    CL, Fleabay, MPS, Local papers... Most junkyards wont sell shells anymore.
  11. flstang65

    Suspension New Shocks

    I have used the strange as well. The only downside is that they can be a little noisy.
  12. flstang65

    Vibration @ 40 Mph

    Good for you!
  13. flstang65

    Need To Find A 4.6l For My 2003 Mustang Gt Help!!!

    Junk yard engine from a crown vic, towncar, grand marquis
  14. flstang65

    Engine 1997 4.6 Into A 1994 Body?

    K member, computer, engine, trans, trans k member, drive shaft, entire hyrdroboost system, wiring harness from firewall forward, probably the dash harness, instrument cluster, computer, exhaust, off the top of my head.
  15. flstang65

    Clearance Problems For Carbed 302 2001 V6

    Drop base on the air filter. 1 1/2-2 inch filter element, GT hood and clearance it under the hood scoop. Hopefully you can still get enough air into the carb. You can play with the height on the filter element.
  16. flstang65

    Clutch Pedal Vibration Please Help

    Hmmmm...maybe check the balance on the fly wheel, check the u joints and the balance on the drive shaft?
  17. flstang65

    Pedal Assembly Question

    brake+pedal+rod - JEGS High Performance
  18. flstang65

    Pedal Assembly Question

    I believe you can get adjustable rods to connect your brake pedal to the booster.
  19. flstang65

    Clutch Pedal Vibration Please Help

    Possibility that the clutch cable could be stretched out too.
  20. flstang65

    Starting To Work On My 70 Sportsroof

    Too much work to make it work when you can take your time to find a 9 inch and rebuild it/clean it up
Top Bottom
Back
Forums
Menu