Search results

  1. S

    Anyone ever use or heard of this Controller

    Thanks. What about the Sniper SP5000?
  2. S

    Anyone ever use or heard of this Controller

    Has anyone ever used or heard of the Ford Motorsports Extreme Performance Engine Control Part numbers M-12650-C80, M-12650-C81 Is it any good?
  3. S

    Congratulations Deuce Bigelow!!! (FOTY winner!!)

    Congrats, Beautiful ride. As are all the others.
  4. S

    Check Engine Light Help

    Ok so I pulled the upper intake and took the spacer out and got a new gasket and marked out the center hole from the gasket onto the spacer and took a 7/8 wood flat bit and drilled a hole in the spacer so it matched up to the gasket and put the intake back together and cleared the computer and...
  5. S

    Can't get TPS voltage above .15 volts - part 2

    Ok I just searched and found your original post, so now I got the full story. I still think there is a ground not making good contact somewhere. But hotcobra03 may be on to something with circuit 361.
  6. S

    Can't get TPS voltage above .15 volts - part 2

    Ok after looking in my Probst book for your codes these are what I came up with KOEO - 67- Neutral Drive Switch (NDS) circuit open; A/C switch on 10- not listed 63- TPS below minimum voltage 96- Fuel pump secondary circuit failure or CM code 96 - Secondary air bypass not working CM...
  7. S

    Transmission Harness Plugs

    The plug with the 2 pins. In the diagram it's circiut 199.
  8. S

    Transmission Harness Plugs

    Here is a wiring diagram for those plugs, Hope this will help you out.
  9. S

    Check Engine Light Help

    So unless I change that spacer to one with a hole that matches up to the intake, I should not be to worried about the code 33?
  10. S

    Check Engine Light Help

    bump
  11. S

    Transmission Harness Plugs

    Ok, is there a way you can take a picture of the two plugs that are not connected? Also what color are the wires going to each of those plugs. You mentioned a possible auto to t-5 swap correct? Also did you try to pull any codes yet that would help alot also.
  12. S

    has anyone ever heard of staab agency?

    Pass emissions??? What is that?? :shrug:
  13. S

    Project "BlackOut" 89 convert.

    Car looks great, stance looks awesome my 89 LX has that low stance and sometimes I hate it. The lower radiator support and bumper cover gets scraped all the time going in and out some of the parking lots because of the way they build roads down here.
  14. S

    Can't get TPS voltage above .15 volts - part 2

    There is a ground on the injector harness that is usually grounded to the back of the heads and I was having voltage problems like you are describing and moved that ground to the firewall and it fixed those voltage problems right up. How are you running a KOER with a code 67?
  15. S

    Transmission Harness Plugs

    The harness that comes out under the car in the trans tunnel has two plugs on an automatic, one goes to the speed sensor and the other goes to the neutral safety switch. But like stykthyn what is the car doing to make you think it is the trans harness? Have you pulled any codes? If so please...
  16. S

    The Official MACn89blckstng Progress Thread

    Lots of work so far and it all looks great. It will surely look great when finished and keep the information coming. Do you have any detail pics of what had to be trimmed / changed to fit that dash and console in?
  17. S

    HELP!!!!

    I would not trade your notch looks cleaner.
  18. S

    Check Engine Light Help

    EGR jrichker, looking at that diagram you posted I think the spacer that I have to run in between my upper and lower intake does not have a center hole in it which I believe would be where the EGR passage is in the tubular GT-40 intake. So if that is blocked will code 33 hurt anything / cause...
  19. S

    Check Engine Light Help

    Ok now that the code 67 is fixed, I decided to try to hook the EGR back up. I have a CM code 33 - EGR valve opening not detected. I tried a known good EGR valve from another car still get code, also the ports on the back of the heads are plugged, vaccum line is hooked up. Will...
  20. S

    Check Engine Light Help

    On the manual harness there are only 2 771 pins even though the diagram shows 3 pins. The one highlighted in red is where it goes in the plug for a manual trans and the one highlighted in blue is where it goes in the plug for an auto trans. a manual harness is 771 to 199, with 26 open. so...
Top Bottom
Back
Forums
Menu