Search results

  1. S

    What intake for my car?

    I have a edelbrock performer 5.0 intake and bbk 70mm throttlebody.What a improvement the intake made great throttle response and mid to top end pulls real hard.When I buy one manufacture I like to stick with there's cause they are made to work together.
  2. S

    What intake for my car?

    I have a edelbrock performer 5.0 intake and bbk 70mm throttlebody.What a improvement the intake made great throttle response and mid to top end pulls real hard.When I buy one manufacture I like to stick with there's cause they are made to work together,
  3. S

    Mustang still handles like an Ox Cart after many upgrades, why?

    No car will handle well if the driver is not smooth with the wheel.I'm not sayin you crank on the wheel like its a 18 wheeler but try drivin smoother not fast abrupt turns but slow and calculated ones.A loose wheel could be the tie rod ends(very cheap).
  4. S

    275/50/15 comp ta drag radials

    Maybe if you got them cheap spring helpers and put the in your rear coils springs up high.That will stiffin up the rear end and maybe not rub.It might lift the rear dependin on how many you need or where you place them.Put them in same place on both sides.
  5. S

    Help, no fuel to plugs

    Hello! I had the same problem and it was the distributor module.When it goes bad the pip in the distrubutor doesn't work right either.That is what tells the computor what fuel injector to fire and when.I don't want to get into deep talk about how the eec and module and pip talk and work unless...
  6. S

    oil pressure

    Hello! I think the wirein on the sender might be groundin some where or the sender.I have a cyberdyne digital dash new oil pressure sender.My gauge reads 39 all the time unless I open the drivers door it goes up to 65 close door back down to 39.I think the ford wirein is the problem try to...
  7. S

    TPS Idle Voltage

    Hello If the idle problem is not real bad just somethin you always pay attentin too and are nit picking leave it alone.It could just be your cam and head mods.I think all 5.0's that are moded have rough idles. Later Sub
  8. S

    help needed!!

    [Hello! Make sure all your plug wires are on right.Then make sure you don't have any wire burnt or cracked arcing on the engine.try two unplug and plug vaccum hose to fuel pressure regulator and check for hiss.make sure all vaccum lines are on right espescialy fuel pressure regulator one. Later Sub
  9. S

    Different? Idle Question

    Hello! I would guess it would be the throttle body not adjusted properly.The idle is not adjustable on the 5.0.The screw on the throttle body is a throttle stop screw.It prevents the blade from gettin stuck.It should be closed and adjusted so the throttle can be floored let off fast and close...
  10. S

    I need some diagnostic advise

    Hello! You 1st have to find out where on the engine it is tickin from.A good way to find out is a mechanics steathascope (like doctor listen to lungs with).You can also use a piece af tubing like old rad house or the like and put it to your ear and move the other and around the engine all over...
View older results
Top Bottom
Back
Forums
Menu