Search results

  1. kboy262

    Those with Off road h-pipe and flowmasters w/o cats....

    I have the Eibach sportlines with my o/r H-pipe and MAC Flowpaths. No scraping issues at all. I even cut 1/3 of a coil on the front to level it off a little better. I did have issues when I had my Dr. Gas X-pipe on. Ground clearance was very minimal. Also the check engine light does not...
  2. kboy262

    O/R X or Catback First??

    I would go with the x-pipe first. Most of your sound will come from the midpipe. The cats soak up a lot of the volume of the exhaust. I buddy of mine use to run a o/r H-pipe and now runs a Prochamber with his stock catback. Its sounds good. Mellow but nice. I like it.
  3. kboy262

    Modular Powerhouse does it again ......

    Tim knows his stuff. Good numbers
  4. kboy262

    Parts needed for PI intake swap (PICS INSIDE)

    I modified mine. Just drill new holes in the original bracket. Takes a couple of minutes.
  5. kboy262

    Eibach Spring Install

    Same here. Very easy install. Just undo the strut and lower the arm with a jack. That was it for me. I have the Eibach Sportlines on mine. Total install time was less than 2 hours.
  6. kboy262

    HELP..L/T's??? Car at Speedshop

    I would wait until you get more air flowing through the motor. You have the intake already. Now just put some cams in. You will get more out of the cams then the LT. To be honest with you I would not even think you will see an increase over 20rwhp with the LT and tuned compared to the X-pipe...
  7. kboy262

    4.10 peeps in here, pronto!

    This is exactly why I am over at ModularMustangs.net and ModularDepot.com now.
  8. kboy262

    PI swapped guys: Intake questions

    Best mod to do without taking the heads off.
  9. kboy262

    40 series flows or SUPER 40's

    To me the MAC Flowpaths sound better. They are a little louder than the original 40s. Also the price is a little less than the Flowmaster. I will probably be flamed, a lot people will say that all MAC stuffis crap. I did the Flowmaster thing first and really did not care for it.
  10. kboy262

    Gear/Tires question

    Also the ride quality will be a little bit rougher some what with the smaller sidewall.
  11. kboy262

    which spark plugs

    Make sure you get the fuel line removal tool or it will be a pain in the butt to take off.
  12. kboy262

    which tires

    I have 20K on mine and they are actually quiter than my Dunlops. Traction in the wet is really not that bad as long as you just don't slam on the gas. I was just figuring for the price they are it couldn't hurt.
  13. kboy262

    40 series flows or SUPER 40's

    To me roughly all the Flowmaster 2 chambers sound the same. The American Thunder kit I quess for almost a year use the Super 40 series muffler. If you check the part number on the kit's muffler and the Super 40s they are the same. TruBlu01 ( I think this is the guy ) wrote up a big report on...
  14. kboy262

    Flowmaster 40 series for side exit exhaust

    Actually you can use a Flowmaster Camaro muffler for a custom side exhaust setup. But to be honest with you get the Spintech Side exhaust kit. Sounds pretty much the same, maybe just a little louder.
  15. kboy262

    Vague s/c question, But any help appreciated!

    What he said. You will have issues with fuel delievery also I believe. You are going from a blower that works off a return style fuel system to a returnless fuel system. I depends I quess in what you get. If I were you just save up and buy one from T&J.
  16. kboy262

    MAC/Magnaflow vs. BBK

    My MAC o/r H-pipe is 3 years old without a single piece of rust on it. It depends on the region. Me living in the south (Louisiana) there really is no corrision factors such as with the snow and salty roads.
  17. kboy262

    MAC straight shot installed

    I never had a problem with any of the MAC products before, until now. I guess I was just lucky in the past. But after this issue I was pretty pissed. Most likely will not buy from them again. Murphy's Law!
  18. kboy262

    mac straight shot installed

    I know I could not beieve it. The metal was not really hot. I touched right when I got home from work. (20 min drive) What I touched was the actual elbow. When I had my original CAI it got so hot it would burn the crap out of my hand. I will probably be flame for saying this thou, but did...
  19. kboy262

    4.10's just installed((WHOA!!))

    You will be fine. Depending on how you drive it really is not too bad. Corampat drives roughly 140 miles round trip to work and I think he said it added an extra 1,000-2,000 miles over a course of a year. I am not sure if I am correct thou, but it was in that area. This should give you a...
  20. kboy262

    I finaly did it! I swaped it, no longer a v6!

    I believe the shut off is around the 6200rpm mark. Do you have a trac-lok in the 7.5" rear end?
Top Bottom
Back
Forums
Menu