Search results

  1. gearheadboy

    Tfi Modules... Any Power To Be Found

    "Dwell is an electronic term that has to do with how long current is supplied to the coil primary windings. An increase in dwell increases the magnetic field inside the coil's primary windings. The coil only puts out a spark when the magnetic field collapses. The stronger the magnetic field when...
  2. gearheadboy

    Build Thread 1978 Mercury Cyclone. The pig is in the pen.

    @madmike1157 Mike? :shrug: You alive there pal? Anyone got one of those pinger detectors? Even a weak signal? I'm sending the PD for a welfare check at the Cyclone garage.
  3. gearheadboy

    Tfi Modules... Any Power To Be Found

    :troll: I'd like to hear this information.
  4. gearheadboy

    Progress Thread Explorer / Gt40 Game

    I talked to Tom via email and he told me I didn't need to port it with my combo. I would have liked to have it ported prior to powder coat but he is right. It will flow fine for this combo. I think this combo will be here a while.
  5. gearheadboy

    Fresh Engine. Low Compression

    Do you have a head off yet?
  6. gearheadboy

    Fresh Engine. Low Compression

    Didn't wanna pull the head in the car I take it?
  7. gearheadboy

    Progress Thread Explorer / Gt40 Game

    I had them milled .030, valve job, cooked, installed my spring kit and set installed height. Needed guides and 1 valve.
  8. gearheadboy

    Progress Thread Explorer / Gt40 Game

    Had time to do some assembly. Cleaned injectors (Explorer 4 hole) and installed new service kits with filters, seals, etc. Note the SN 95 fuel rail. And I got a call from the machine shop....
  9. gearheadboy

    Build Thread 1978 Mercury Cyclone. The pig is in the pen.

    Obviously Mike is too busy getting dirty, injuring himself, etc to post. I'm expecting a large post with lots of pictures after the weekend.
  10. gearheadboy

    87 5.0 Head Gasket Problem

    The gasket is backwards. My first guess. And second it very well could be the intake gasket/intake, not the head.
  11. gearheadboy

    Fresh Engine. Low Compression

    Now you are making some sense..kinda. Is the #3 injector stuck open? Dripping in? That'll put fuel in the oil in a hurry. And it will wash down one cylinder. PS if it has that much fuel in the oil you DO NOT want it to fire at this point. KABOOOOOOOOOM! Change the oil before you get a good spark...
  12. gearheadboy

    Fresh Engine. Low Compression

    Rockers backed off? And did you check the distributor with it on TDC? To make sure it hadn't changed?
  13. gearheadboy

    Fresh Engine. Low Compression

    I'm not seeing the PTV clearance as being checked properly. It has no compression. Bent valves? Timing chain jumped? Back the rockers off on one cylinder and air that cylinder up. See where the air comes out. Intake..Exhaust..or crankcase. The fuel in the oil is because it isn't burning it. It...
  14. gearheadboy

    First Time At The Track After Gt40p's

    I'd bet with that combo that the drag radials would hook it right up too. And I have a 3.73 in mine and I feel it is very streetable. If it was my daily and I was a commuter I MAY go with a 3.55.
  15. gearheadboy

    Mid Atlantic Mid Atlantic - PA, NJ, DE, VA, MD, WV

    Its all good. It is still there every Saturday night. Starts at 6? Till like 8 or 9?
  16. gearheadboy

    Drivetrain 89 Mustang Shift Linkage

    Umm..there is NO shifter linkage. Try again. Pull the console, boot, lower boot, shifter bolts and pull it out. Broke the shifter, the bushing is pooped, or the trans. Let us know.
  17. gearheadboy

    First Time At The Track After Gt40p's

    Keep the gear in mind when you swap your tires out. A taller tire will kill the 60 ft with your gear. If you wanna keep the gear thats ok, figure it into the tire size equation if you want to have lower 60 ft times. Anything that hooks will be an improvement though.
  18. gearheadboy

    Build Thread 1978 Mercury Cyclone. The pig is in the pen.

    It's a Fairmonchero. Neighbor guy had one with a cap on it. o_O