Search results

  1. 9

    98 power ?'s

    i believe it is a dynojet. i know it isn't a mustang dyno. my other ? is, every time i put a new part on i can feel the difference for about a weak. then it seems like it goes away. is it just me getting used to the car or is the computer adjusting for the parts.
  2. 9

    98 power ?'s

    what kind of gains could i look at with a good chip and tune.
  3. 9

    98 power ?'s

    i was just woundering if these #'s sound right with the mods that i have done. i thought they were low but i might be wrong. any info or suggestions would be great.
  4. 9

    Looking for the Perfect 98Cobra

    what state are you in. i have a 98 cobra vert. that i have been thinking about selling for 16,000 with 26,000 miles. it is black but has tan int. sorry.
  5. 9

    99 Cobra tranny removal help needed!?!?!

    same thing here. 3-4 foot ext. when you try to actually pull the trany out. if you lift up on the front of the motor it will be a lot easier to slide out. same for install. just lift enough to angle the back of the motor down.
  6. 9

    Just got a Rear Seat Delete

    looks good. i am planning on doing the same when i change my interior. glad to hear that it was easy to put in.
  7. 9

    how restrictring are the sidepipes??????

    i have the borla side exhaust on my 98 cobra. from what i hear this is one of the few side pipe kits that don't hurt your hp. they don't help it, but they don't hurt much. they do look and sound great. the 180 bend is in the muffler. as far as other kits go i'm not sure. the only problem that i...
  8. 9

    98 Cobra Cutch Adjustment

    i have tryed pulling back on the pedal and it didn't feel any different. i only have 25000 miles on it. it doesn't feel like it is slipping bad but the grab is not what it used to be and the pedal is really high. any other idea's other than replace it with a better clutch.
  9. 9

    98 cobra misfiring

    i am having the same problem. it is fine if i leave it out of gear an bring it through the rpm's slowly, but if i am moving and i floor it in first then a around 5500-5800 rpm it starts back firing as if the rev limiter has kicked in early. i have no idea what it is. it doesn't seem to be as bad...
  10. 9

    Putting gears in a 98 Cobra

    i put 3.73 gears in my 98 cobra and all i did was buy a $12.00 plastic speedo gear from summit. everything is fine. just make sure that u get the right speedo gear for the gears that you get. as far as the shorter gears needing a speed cal, i don't know, i didn't go that high but the 3.73 gear...
  11. 9

    Bassani x-pipe/ is it worth it???

    i haven't had anyproblems with anything leaking or falling off like i said it is just surface rust. i can't complain i love. if i were you i would get it.
  12. 9

    Bassani x-pipe/ is it worth it???

    i have a 98 cobra with bassani x-pipe with hi-flow cats and i have had no problems. it is very easy to put on because it comes in a few pieces. the only complaint that i have is that they advertise as all stainless, and it is, except for on part of the flanges on each side. that has some surface...
View older results
Top Bottom
Back
Forums
Menu