Search results

  1. mogs01gt

    Tps Question

    The fuel pressure should be stable. 57psi is pretty high but you do have an after market pump. My money its the tune, didnt realized you were that modified. Are you sure your throttle isnt sticking?
  2. mogs01gt

    Tps Question

    The car will run without the MAF plugged in but it wont rev properly. Make sure the idle screw is set properly. all you should do it unscrew it all the way, then lightly tighten it until the throttle blade moves a bit. Get some starter spray and spray around the vacuum lines and plenum. DO...
  3. mogs01gt

    Tps Question

    This doesnt sound like a TPS issue, try cleaning the IAC first.
  4. mogs01gt

    Pi Head Install

    I would spend the cash and have the heads checked. Just to make sure the valves are sealing properly.
  5. mogs01gt

    My Car Must Have A Bigger Engine Than A 4.6l

    LMAO great troll thread.... If you are in Ohio, I'll run ya to see how "big that engine is"
  6. mogs01gt

    Modular Depot. Final Verdict 7 Years Later.

    Disabled emissions is normal, Engine misfire is totally separate... Your car probably doesnt have rear cats correct?
  7. mogs01gt

    Aluminum Block?

    No they arent.
  8. mogs01gt

    Dowel pins don't fit new flywheel

    I was going to say it sounds like the wrong clutch. Pick one up from Summit.
  9. mogs01gt

    Need some tips on valve seals for the people that have done it. (engine on stand)

    Magnetic flat head plus a small amount gear grease. The grease puts some friction on the pieces and can old them together.
  10. mogs01gt

    Aluminum Block?

    The internals are the same and the block itself will handle more power than you can afford :P. If its a 4v block, you will need to drill a coolant passage hole on the driver side of the block. yes its worth it!!
  11. mogs01gt

    coolant tank delete!

    May I ask what heads you are running? You put out similar numbers to my car but about 30 less torque.
  12. mogs01gt

    Engine seized!

    Do you have an oil pressure gauge? Might have snap the teeth on the oil pump earlier that day.
  13. mogs01gt

    Tank_567 Turbo build

    How much ground clearance do you have with the downpipe underneath the K member?
  14. mogs01gt

    nitrous on a teksid 2v?

    Do no skimp on your rotating assembly, get forged internals. If you must skimp, stick with the gt crank. They can handle lots of power.
  15. mogs01gt

    v10 swap

    Ford did it already. YouTube - Mustang v10 mule not practical
  16. mogs01gt

    400 Hp build N/A Then a bottle

    400rwhp or 400 at the engine? 400 at the engine is perfectly durable without going to a carb setup.
  17. mogs01gt

    Nitrous

    a timing adjuster is only going to adjust your base timing, you will be on borrowed time without a full tune.
  18. mogs01gt

    Nitrous

    Yes you will have to retard the timing, you better get a tune as well.
  19. mogs01gt

    Heads?

    No, you have to drill a 4v block for 2v heads. The Trickflows arent hyped.
  20. mogs01gt

    No power after 5k?

    Clean out your TPS, replace the fuel filter and check your plugs. It should pull till 6k.
Top Bottom
Back
Forums
Menu