Search results

  1. D

    Cylinder full of fuel/ plug not fouled

    Is this the signs of a bad/leaking injector? Checked all plugs and #7 soaked in fuel/ but looks very good(maybe not firing). Before morning startup I checked fuel pressure in the rail and had none. Started car, and checked for spark/spark is fine. Then swapped a new plug in #7/ same results(fuel...
  2. D

    Cold weather problems(eec tuner)

    This freezing weather has my car running super super rich to the point where my exhaust smokes and reaks of fuel. My car sputters misses and runs like ass. I have a tuner and was wondering what I could tweak to lean it out a bit in the cold? Any other suggestions would be appreciated.
  3. D

    Is a 1262 port job too big for 306 or 331?

    I was wondering, b/c my heads were ported here by a reputable porter to a 1262 gasket. I have them on my car and she runs like a beast. I have a ported GT-40 intake. I'm looking to get a systemax intake(port matched lower). Is that too much porting? I have a 331 stroker kit, I've yet to build...
  4. D

    Couple pics after I washed my car

    How do I post pics on here?
  5. D

    warm stahling problem...please help

    I figured mine out. I changed the ect sensor and got rid of my cold start problems. I soon developed a hot start problem. I couldn't shut the car off for a few minutes without having the car stall on startup. I needed new O2's ... helped with driveability but not hot starts. I changed my iac and...
  6. D

    HELP AGAIN. Timing trouble (i swear this is the last time)

    If you skip the finger thing twice you can still be off. After you skip the finger n hole thing the first time and start your motor,if it's off, the rotor turns and you have to start over again. Just do the finger n hole method and do it right the first time. Pull your dizzy out, bring your #1...
  7. D

    List of gaskets needed for H/C/I swap

    EGR gasket, T-body if you remove it. That's about it.
  8. D

    Head torque ???

    What are the torque specs for aluminum heads? What do you use on the threads to read torque? I'm using ARP head studs on tfs tw heads.
  9. D

    Anyone have Autometer Elec oil press guage?

    I have the phantom electric oil press guage and lost my wiring diagram. I need to know which posts on the guage wire to what. Thanks in advance.
View older results
Top Bottom
Back
Forums
Menu