Search results

  1. Mr. Rustypwnz

    New Turd! (4.6 Content Warning)

    Picked this one up off of a buddy. Has all the common bolt ons + cams and 4.56 gears. The 4.6 section is lame, so I posted here! lol
  2. Mr. Rustypwnz

    8 Bolt Or 6 Bolt Flywheel

    Your 2000 has a 8 bolt crank, the 2003 engine has a 6 bolt crank.
  3. Mr. Rustypwnz

    My Names 5.0droptop.........

    Bass blockers
  4. Mr. Rustypwnz

    Thoughts On Trick Flow #2 Cam

    I have never had any problems with this. It wont make 350 with those heads though.
  5. Mr. Rustypwnz

    First Mustang What Mods To Do First ?

    Pull the engine, throw it away. Install coyote engine.
  6. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    Totally understand this completely. However its usually just barely noticeable, and 99.9% of v8 mustangs have some type of aftermarket exhaust installed, so its damn near impossible to tell a difference.
  7. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    But a tubular K will just break if you install it! I read it on the internetz somewhere :scratch:
  8. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    Well, I live in Indianapolis. The roads look like they got carpet bombed. I still don't have any noise what so ever. Maybe your buddies never actually tightened them up all the way? Im still cornfused about how a welded piece of tube will make it louder?
  9. Mr. Rustypwnz

    98 Cobra No Crank No Start

    There is a white/red stripe wire by the fuse box. This is the excite wire for the starter. Take the car out of gear and bump this wire to the + side of the batt. This will tell you if the starter is good/bad. Even if the theft system is engaged, it should still spin over.
  10. Mr. Rustypwnz

    Is The Wap Really That Bad?

    Whoever said they will fail at 200hp is mentally retarded. Yes the teksid is better than the wap. By how much? a very slim amount. Any of the modular blocks will hold over a 1000hp (4.6-5.4) The REAL question is, how much power do YOU want to make?
  11. Mr. Rustypwnz

    Someone Draw A Line In The Sand For Me

    A 6.0 will spool that bitch with the quickness.
  12. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    How does a k member make it go, "BANG....BANG....BANG....CREEEEKKK...BANG....CLUNK....BANG....BANG!!!"?
  13. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    The truth has been told! On a 5.0 car its not really needed. That one time your starter dies though....
  14. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    LOL! 3.55's.
  15. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    x2
  16. Mr. Rustypwnz

    Popular Mods That You'd Recommend To Not Do

    x1
  17. Mr. Rustypwnz

    Piston Ring Gap

    I usually put em around .025 top, .0235-.024 second.
  18. Mr. Rustypwnz

    03 Gt Needs Attention

    you need to change the plugs and take the coils apart and clean them with a wire brush, then brake clean them off. Put dialectric grease on the coil where it meets the coil and the plug itsself. Only use motorcraft coils and autolite 764 or 103 plugs. Water in the plug wells is kryptonite to...
  19. Mr. Rustypwnz

    Someone Draw A Line In The Sand For Me

    yeah except you actually have a real hotside lol. If your doing a 5.3/cam I would do the standard s475 with the 96mm turbine 1.32 housing. Dont worry too much about the spool time, with the right tuning and cam timing it will light off pretty quick. (I havent read your entire build thread, so...
  20. Mr. Rustypwnz

    Opinions For A Streetable Combo

    150 shot = tada!
Top Bottom
Back
Forums
Menu