Search results

  1. klaw

    A question for the experts

    CAI, tune, and gears (4.10's for N/A, 3.73's if you're going FI in the future or drive alot of highway miles). It's surprising how that will wake your car up.
  2. klaw

    20" Rims - Can I see them pls

    The 5-spoke 20's seemed too open so I went with the retro Shelby 10-spoke CS66's There's additional angles in My Garage: klaw's Garage :: BLWNPNY
  3. klaw

    A question for the experts

    The GT500 supercharger will bolt on top of a Roush TVS 3V intake manifold which will fit your 4.6.
  4. klaw

    what's your "my color"?

    I leave mine set on the blue and have done the LED changeout of all the green to blue as well. I much prefer all blue to any green. I especially like the blue in the steering wheel.
  5. klaw

    Is there a cam for a SC car?

    I have Comp blower grind cams (Stage II SPR) in mine (Whipple at 16 psi). Many options available from a variety of vendors.
  6. klaw

    2006 gt Tyco electronic

    I'm pretty sure that's just the connector like JustMe09 said.
  7. klaw

    Couple more new pics...

    Damn that's a fine looking machine!
  8. klaw

    Plug Wires

    Our cars have a coil on each plug whereas a conventional old-style iginition had one coil and distributed the high voltage through high voltage plug wires. You don't need to change the plug wires in our setup but on occasion you might have to replace a coil (referred to as a "COP" -...
  9. klaw

    Cobra badges with Roush body kit

    Good idea? No.
  10. klaw

    Steeda 10 rib system

    I ran a braided line from the hardline at the frame rail to a high flow tee (internally contoured) then braided lines to each rail. Fitting...
  11. klaw

    Steeda 10 rib system

    I went to aftermarket fuel rails and braided lines to reduce the chance of any restriction due to the crossover to the passenger side.
  12. klaw

    Need help spending money

    Buy lots of gas and just enjoy the hell out of it!
  13. klaw

    Steeda 10 rib system

    You're probably going to have throttle tip-in issues. Essentially, the tune will likely have trouble matching the air/fuel at low RPM and the engine will have a tendency to stumble. Who is doing your tune? These builds take quite a bit of work to nail down street driveability. You'll probably...
  14. klaw

    Steeda 10 rib system

    I have the Steeda 10-rib with the 16psi boost pulley. My car isn't the easiest to tune but that's more related to the cams than the blower drive. Are you having issues? What's your setup? A reasonably complete list of my mods is at: klaw's Garage :: BLWNPNY
  15. klaw

    COMP CAMS STAGE 2 CAMS or FRPP HOT RODS

    YouTube - My 2007 Whippled Mustang at idle
  16. klaw

    SOS Gauge pods

    I have the SOS triple pillar pod with Raptor and recently added a pyrometer in the driver's left vent using a Roush vent pod. The fit and finish of the triple pod is the best I've seen out there although I have seen one on another car where the pod alignment wasn't perfect. Mine is. As far as...
  17. klaw

    SOS Gauge pods

    Simple
  18. klaw

    Should I sell?

    not bad actually - it cost me about half that just to get my shortblock, heads, and headers shipped from Michigan - and there were no oceans to cross.
  19. klaw

    Should I sell?

    what's it cost to ship it if you don't mind me asking?
  20. klaw

    pics of 1.5"+ lowered mustangs with 20s?

    What size are you looking for? A guy I know went out of business and had some in chrome and anthracite last fall - low chance he's still got them but might be worth a shot. My car has changed alot since you saw it last (not much on the exterior). Current state of the project is summarized at...
Top Bottom
Back
Forums
Menu