Search results

  1. B C

    13 inch rotors/brake upgrade - discbrakesrus.com

    Rusty ones. Those definitely are not Powerslots. Powerslots are nickel plated and will not rust.
  2. B C

    SLP new Brake Control-Package

    I bought the SLP unit right after the FFW in Phoenix mainly because I smoked my clutch real good doing the 4k dump in second. I was really sucking on the burnouts until someone told me about the 4k+ dump. I guess while trying to focus on keeping the RPMS up I rode the clutch a little and major...
  3. B C

    SLP new Brake Control-Package

    $130
  4. B C

    SLP new Brake Control-Package

    I have one. It works great. Install is easy. It is a complete kit.
  5. B C

    KB and Fuel Pressure

    Sounds normal
  6. B C

    did 3 1/2 turns on my differential... what gear ratio do i have???

    Almost 3.5 turns sounds like it could be 3.27 gears. Was it a just over 3.5 turns or less than 3.5 turns?
  7. B C

    Aftermarket Radiators

    I have the Fluidyne and it is very nice although expensive. You might want to look at the 03 Cobra radiator. $299 but you might be able to get it cheaper from Randy Stinchcomb here; http://forums.modulardepot.com/forumdisplay.php?s=&forumid=21
  8. B C

    Best Rear Differential Cover/Girdle For 99-04 Mustang GT?

    I have the SVO girdle. It does have a drain and fill plugs and also has load bolts provide additional support for differential bearing caps. It also increases the fluid capacity a bit. They also have a stud kit that replaces the bearing cap bolts that I wouldn't bother with unless you are...
  9. B C

    When you run a Mezeire elec water pump do you

    I have the relay. It is a better way to wire the pump. It will be wired directly to the output terminal of the alternator or battery. The relay gets wired to a keyed switch and turns on the power to the pump when the switch gets current. That way you aren't sharing power on a circuit with...
  10. B C

    When you run a Mezeire elec water pump do you

    My Meziere comes on when I turn my key on. It isn't hooked up to the fan at all. In fact the instructions I got said nothing like that.
  11. B C

    which car should i get 01gt vs 99 svt

    Cobra over the GT but I would check on insurance first. The Cobra might be quite a bit higher to insure at your age.
  12. B C

    KB Dyno #s

    Does Roush put on a speed limiter?
  13. B C

    KB Dyno #s

    I haven't been 135 mph but my car has been on the dyno numerous times in 4th gear up to 6100 rpms or so. I was told that the Kenne Bell chip does not modify the rev limiter whatsoever. But I would ask Ken to be sure. Hopefully you get this resolved soon. I would get rid of that BBK and go back...
  14. B C

    Factory 'vert subframe connectors enough?

    Just the subframes are around $100 plus about $150 or so for install. The Kenny Brown subframes, extreme brace and jacking rails are around $300 plus about $300 or so for install.
  15. B C

    Factory 'vert subframe connectors enough?

    I had the same bolt on subframe connectors that came stock on my Bullitt. They helped. I took them off for about a month prior to getting some new full length ones and I could easily tell the difference without any compared to having the stock bolt ons.. So the stock ones do help. I was...
  16. B C

    KB Dyno #s

    I didn't realize you were actually running the BBK. The 90mm maf and their CAI is the way to go. On the dyno, make sure they go through the gears and into 4th. Tell them you want it , want numbers at WOT for 2500 rpm's through 6100. They might not be familiar with running a dyno on a...
  17. B C

    Any difference between a 01 and 02 GT?

    I think the heads are supposed to be better in the 02's. It has been rumored that the 2001 GTs have a higher compression ratio due to a head casting error.
  18. B C

    KB Dyno #s

    Your numbers would be around the same as the others if they would have let it go up to 6000 rpms or so. It doesn't look like they know how to use the dyno unless there were some other issues to why they did it all that way. But something is definitely wrong with the a/f. I hope you...
  19. B C

    KB blower questions

    www.kennebell.net
  20. B C

    clutch went out, ouch *pics included*

    Scroll down the post below a bit, Hammer posted some good info here about clutches. He recommends the McLeod Twin disk. Lots of people recommend it. That is what X2C recommends for their TKO too. http://www.modularfords.com/forums/showthread.php?t=8104
Top Bottom
Back
Forums
Menu