I don't have alot of time left before this "rejection" sticker grounds me.. I'm pleading.. if any of you have the steel tube that goes from the AIR hoses to the H-Pipe please let me know here or at [email protected].
Thanks!
HEY HEY HEY!!! If your going to remove that steel tube that goes to the H-Pipe.. DO NOT HACK IT UP! I'm in desperate need of one! There are two bolts that hold it to the car.. one on the back of the passenger side header and one on the bottom of the car near where it connects to the...
I figure there won't be many quirks.. the only difference between then and now is the upper end. The bottom end of the engine is the same from what they say.. Who knows about the trans though. Might be garbage.. ??? :D
However I don't know if I'll get rid of mine (even though it's...
Does anyone have or know where I can buy online so universal cats.. or some *cough* GUTTED CATS *cough*...
If anyone has gutted weld in cats or a H or X with gutted cats and you want rid of it.. let me know..
I'm desperate to pass a visual inspection!!!
No I rarely rev it or show off anymore..
Stopped at a road stop and he heard it idling (which isn't that loud) and looked up under it.
Plus I can't pass inspection. However they don't check for emissions..
But If I'm going to have a catted pipe I guess I need to hook all my...
Right now I have an off road H.. but I finally got caught with it so I figure it's time to go back to legal.
How much power am I going to lose going with a catted H or X.. is it going to be enough to feel and be depressed about it.. HAHAHA.
And if anyone has one they want to sell...
Believe it or not.. Nitto's don't do so bad in the weather either. I've had them in the ran and slight powdering of snow with minimal problems. And when you heat them up they hook pretty well.. hehhehe.
I'm sure Bassani is great.. but for right now I'm just wanting to know where to buy each..
So if anyone knows where I can look on here for a Mac X pipe let me know.. I've found all the others.
I didn't know Mac made an O/R X... It's not on their site is it? Where did you buy it.. My H is in pretty good shape.. the H part looks like it has surface rust on it but it's where my tranny spilled oil all over it and burnt on it.. There are no leaks..
But either way let me know...
Get some spring lock coupler removers.
Make sure you have little or no gas in the tank..
Relieve fuel line pressure...
Disconnect all hoses and lines going to the tank and drop tank.
I haven't done this in a while but I think there is a seal you'll have to remove and replace. Either way...
Hell I've got a set of 3.55's with less than 10K on them in great shape (no visual blimishes and not warped or anything) that I'd give away for cheap...