Search results

  1. S

    Engine Bog Question -Any Ideas???

    Same problem...three times before but never again I had the same problem and did the same things: fuel injection clear, replace FP, replace TFI, etc., you name it I did it. :notnice: The Stang would go through the same sequence: hard/long start, rough idle, popping under acceleration and...
  2. S

    15/16" master cylinder vs 1" w/88 Booster

    If you haven't done so, use the info at the svo73mm website http://mjbobbitt.home.comcast.net/mustang/mc.html to help you with your setup.
  3. S

    Anyone with a higher mileage AOD?

    I just went over 200k on 89GT and no problems. Been on top of the fluid changes at the end of every summer, usually around Labor Day just for reminders. Still runs strong with no slippage, knock knock. I'll get around to the valve body upgrade soon.
  4. S

    Check engine light and no self test...WTF?

    No. The CEL went off as soon as I cleaned up the grounding points around the car, specifically the one near the computer. I also swapped out the negative cable for a heavier gauge (4 ga) and cleaned up the contact on the block. I had a 130-amp alt for a while and u/g the main cable just recently.
  5. S

    3G Alternator upgrade

    I did the same upgrade but didn't do the wires until recently. Think of it as blowing water through a straw, small straw less push of the juice through. The upgrade will not only require the newer 4 gauge alt cable, but also upgrade the grounding cable as well. Here's one site to add to the...
  6. S

    Check engine light and no self test...WTF?

    Grounding did the trick Thanks autoXr1. Your advice did the trick. I've had Mustangs for 14 years (this one for 10) and have done all of my own work: upgrades, electrical, diagnoses, etc... but this was a first. I guess going to an upgraded 4 gauge alternator cable so the 130 amp alternator can...
  7. S

    Check engine light and no self test...WTF?

    Anyone come across a 5.0 that would not do any of the self tests (KOEO/KOER)? I got a check engine light and tried pulling the codes with no luck. I've traced the wires for any faults and have come up dry. Still runs though. :shrug:
View older results
Top Bottom
Back
Forums
Menu