Search results

  1. Slo5Oh89

    Oil Pan Damage Question.

    So the Sway Bar can move upward that much? This was also a issue before I changed the bushings. I will pull it off and look for signs of rubbing when I upgrade the front suspension
  2. Slo5Oh89

    Bumpsteer kit???

    Ok great I am using Stock K-Member, spindles. And only dropping an inch or so. I may replace the 24 year old ball joint though.
  3. Slo5Oh89

    Oil Pan Damage Question.

    Before I changed the sway bar bushings I was having this issue but that is interesting. I reused everything but the bushing when I attached it back. But I could take the sway bar off drive a little and see. Could bad suspension be an issue? No swaybar for a short time wont hurt anything right?
  4. Slo5Oh89

    Oil Pan Damage Question.

    I have some damage on my pan in the picture below. This happened couple years ago and has gotten worse. BUT my friend had a good point of not seeing any scraping on the bracing under (And its a Convertible). I put a new front sump drain plug in the other day drive for 10 miles look at it and it...
  5. Slo5Oh89

    Bumpsteer kit???

    I am putting on ford racing spring , mm caster camber plates, new struts, mm strut tower brace..Already have mm weld in subframes, k member brace. Dont know much about bumpsteer kits.. Should I invest in it? anything else I should look at replaceing like ball joints?
  6. Slo5Oh89

    Lower control arm question.

    Got it!!!!!! The ratchet strap idea took 5 min after the strap pulled axle forward! Thanks as always
  7. Slo5Oh89

    Lower control arm question.

    I only unbolted the one side. I read numerous articles saying to do that is the reason why.
  8. Slo5Oh89

    Lower control arm question.

    I have tried it with and without the new spring. But I have not tried some of the ideas above..
  9. Slo5Oh89

    Lower control arm question.

    I have a 89 vert and I am doing changing shocks, quad shocks, springs. I have everything changed but can not get axle bracket to line back up with lca. That would explain why bolt was so hard to remove... ideas, tips?????
  10. Slo5Oh89

    strut choice ideas.

    Thanks guys. I have seen nothing but good about tokico blues. My 24 year old 74k miles set up bottoms out and damages oil pan. Dont want to fix pan till that problem is fixed! rear suspenson is next. I liked what I read about the frpp sprins dont want to lower much have 17 inch cobras
  11. Slo5Oh89

    strut choice ideas.

    I am going to replace my struts and price and selection vary. I have a 89 vert. Kyb is cheap Bilstein is one I seen that I liked. My car is a weekend driver but I like cur es and a good ride. Would I be as happy with the kyb as say bilstein or others. Any revews ir ideas. and any ides on a good...
  12. Slo5Oh89

    Electrical Hidden Security Ignition Switch.

    Thanks guys! I have an '89 so from what I read is the red and black wire that goes to the fuel relay under the drivers seat? Thank you guys ONCE again for the awesome advice. Now forget about where this switch is in my car haha! JRICHKER you the man.
  13. Slo5Oh89

    Electrical Hidden Security Ignition Switch.

    I am looking for a way to add a switch somewhere hidden that will disable the car when it is stored. Never know also when someone might want it. I would like to install a toggle switch somewhere that would be hard for someone to find that would disable the car from hot wiring or even if someone...
  14. Slo5Oh89

    Alignment Off.. Guess Why?

    Well when the sub frames were welded it was on a lift the garage. And I put the end links on in the garage. But it was like before these mods then it has just started to get off more and more. This winter I am looking at new springs, adj shocks struts and caster camber plates
  15. Slo5Oh89

    Alignment Off.. Guess Why?

    My car is pulling to the right and I am not sure why? I performed some mods and it got way worse. In the last 6 months I have had MM Subframe connectors welded on, MM K member brace, new sway bar end links and each time got worse. Is it just from getting the car more stable? Ideas? Should I just...
  16. Slo5Oh89

    Code 12 And 91 Check Engine Light On.

    Thanks for the reply. Just to veify I should replace the O2 sensors? Also in addition to cleaning the 8month old IAC with 1200 miles on it what should the base idle be and what should it be with the IAC? I have not had idle issues with for quite a while.
  17. Slo5Oh89

    Code 12 And 91 Check Engine Light On.

    I have a '89 5 speed convert. I checked my computer and got code 12 and 91 I see that 12 is base idle what should that be with my IAC unplugged? Also 91 is a O2 sensor correct? If so I will replace them both they are the stock originals from '89. Any other ides or suggestions?
  18. Slo5Oh89

    Ideas for next upgrade!!!

    I have a fairly stock '89 Convertible LX 5-Speed 74K original miles. Below is a list of my mods. This car is not a daily driver. Would like to stay under 350 3.73 Gear (I know 4.10 would of been more fun!) Steeda Tri Ax Short Throw Shifter Maximum Motor Sports Adjustable Clutch Quadrant Kit...
  19. Slo5Oh89

    MAF Question need your expert advice!

    10-4!
  20. Slo5Oh89

    MAF Question need your expert advice!

    Is it possible to put the stock sensor in that bigger housing?
Top Bottom
Back
Forums
Menu