Search results

  1. toyman

    Electrical 95 Gt 347 - No Cranking Possible Tps, Maybe??

    The TPS signal to sensor ground in the closed position should be about 1v. WOT about 4.7v with a smooth transition between the two readings. Yes, the ecu will shut off the injectors at WOT. (Flood clear mode) Not certain but I think it's at about 75% which is 3.75v. The voltage reference reading...
  2. toyman

    Bad Distributor?

    The 94-95 GTs have the OBDI port on the passenger side engine bay. The OBDII port is for the V6 for those years. Ford found it cheaper to make a common harness for these two years.
  3. toyman

    Bad Distributor?

    Trouble codes are three digits so 14 isn't correct. The PIP (Hall Effect Sensor) in the distributor is a common issue. FWIW reman units quite often pass a defective PIP so consider a new one. Richporter distributors can be had for the price of a reman. A clean MAF is critical so make certain...
  4. toyman

    Cost To Replace 86 Convertible Top

    I bought a vinyl top from these guys about 12 years ago and it still looks new. The installer was impressed with the quality and fit.
  5. toyman

    Somebody Who Knows What They're Doing: Help!!

    You can buy an OBDI reader here for under $25.
  6. toyman

    Fox Installed New Distribitor Now Getting Random Stall.

    A clogged fuel filter or a failing fuel pump would be my first guess.
  7. toyman

    Somebody Who Knows What They're Doing: Help!!

    You need to post the trouble code numbers. As mentioned in another post the code port is in the engine bay passenger side on the strut tower. There are different ECUs for for these years depending on gearing and transmission configurations. O2 sensors are critical and must be the correct ones...
  8. toyman

    Choosing A Cam Shaft

    That's the cam in my combo based on the engine builders recommendation. I thought the 284HR might have been another choice but was told that the idle would be quite lopy. The 270HR has a solid idle at 850 rpm.
  9. toyman

    94 Stang Power Loss Problems

    Did you ever replace the fuel filter? I still think it's a pump issue though.
  10. toyman

    What Will It Take To Run High 12's In My 94gt

    I think you will need a HCI combo to get there.
  11. toyman

    Power

    The expression is "when push comes to shove". I think the OP is looking for a S/C for a street car that is driver friendly and won't be a gas guzzler. To the OP, having a S/C doesn't mean you use more gas unless you have a lead right foot. The injectors will likely be 24#, which will probably...
  12. toyman

    94 Stang Power Loss Problems

    You really don't need an adjustable regulator and may not even need to replace the stock piece.
  13. toyman

    Cel Help - Here Are The Codes

    May be as simple as a dirty MAF sensor element. I would clean it first. If the codes still persist after they have been cleared, then switch the O2 sensors to see if the problem follows the sensor. If it does then the O2 sensor is likely the culprit.
  14. toyman

    94 Stang Power Loss Problems

    I like the KB. In full boost at about 2200 rpm delivers a lot of low end torque. However, KB stopped making them for our cars last year.
  15. toyman

    Spark Knock

    Tell us specifically what you did for the tune-up. What is the timing set to and did you remove the "spout" connector before setting the timing. Has the MAF element ever been cleaned?
  16. toyman

    94 Stang Power Loss Problems

    Most likely the pump. While it's over kill for your application I would still get a Walbro GSS340 255 lph fuel pump. About $100. Because these systems return excess fuel back to the tank the high flow rate isn't an issue.
  17. toyman

    Auto Stalls when put into Drive or Reverse

    I would suspect the TC or the TC solenoid. Go over to "clickclickracing". These guys know auto transmissions.
  18. toyman

    1995 Supercharged Gt Stalls When Warm?

    Are you saying just because you don't have a CEL you don't have a trouble code? Lots of codes are logged without a CEL showing. If you have a code reader use it. There well may be a code that will point you in the correct direction. Do you know what tuner is managing the ECU function or is the...
  19. toyman

    Auto Stalls when put into Drive or Reverse

    Did he explain what "too tight" means?
  20. toyman

    Auto Stalls when put into Drive or Reverse

    I don't think it's a converter issue. Pull codes and check for an air leak.
Top Bottom
Back
Forums
Menu