Search results

  1. paintballpyro1

    Expired mustang trans,speedcal, misc parts

    I have been swapping motors and transmission on my 96 and have some parts left over. All parts are off a 1996 mustang all items located in waterford,mi. I have 96 gt 4r70w auto trans and converter---does have a small leak and wasnt selecting gears correctly but i believe its due to a rotted...
  2. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    drove it around the block and was not running right at all, boggin down, even tho i shifted into 2nd and 3rd rpms never dropped, was revving to 2500-3000. It felt like i was driving my busted auto not cycling gears....im at that point im losing interest of my car and thinking of just putting the...
  3. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    Finished the spark plugs and doing the fuel pump, still having the issue but not as bad I think. Once running if I tap the gas it bogs a little a few time then the issue goes away.
  4. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    Once the cars running its fine. Where is the fuel pump relay located?
  5. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    After some search when you have the key on,engine off there should be 30psi at the rail. I pressed the schrader valve down and only got a quick squirt then it just barely trickles out. Assuming then this would indicate bad fuel pump since fuel regulator tested ok?
  6. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    Ecu was for a 96-97 4.6l.5-speed. Zxa4 was the code on the ecu.
  7. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    Tried using the fuel pressure gauge. Not sure if the gauge is broke or what but hooked it up key on engine off needle didn't move, started the car needle still didn't move. Shut the car off and pressed the little fuel valve and had no pressure. Assuming bad fuel pump possibly since fuel...
  8. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    When i pulled the motor i dont remember seeing a ground cable from motor to chassis. Where should it be located? Also used my multimeter and was seeing about 12.8-13volts. Wasnt sure where to check but tested over alternator, thermostat housing, block and all came back at 13. Im assuming my...
  9. paintballpyro1

    Engine swapped motor, having starting issues(wmburns?)

    So i recently just swapped my 96 gt motor out for an 04 with 59k. While waiting for parts i came across a 5-speed conversion with everything minus computer for $600 which i thought was a deal. Swapped out ecu's for a manual one. Fast forward swap goes ahead and it bolted into the car, it runs...
  10. paintballpyro1

    Drivetrain Throwout bearing replacement

    atleast lrs helped you, i bought a few parts from them and was missing hardware for my quadrant and all they offered was 5% off my next order even tho we get 5% being part of the forums. Never even offered to send the hardware.
  11. paintballpyro1

    Drivetrain New to t-45, what do i need?

    Just picked up a 5-speed conversion for $600 for my 96, everything looked good just need a few parts and some info. I know i need: throwout bearing pilot bearing(do i need?) shifter base and handle gasket Fluid(whats recommend/best?) Anything else? Also i do have the stock clutch cable but i...
  12. paintballpyro1

    4r70w questions

    In the process of swapping my motor and going to be changing trans fluid as well. I noticed since its been sitting its been hard to shift out of park into drive or vise versa(thinkin about the shift cable?) and has been not going into the right gears ie: I have to put it almost into neutral for...
  13. paintballpyro1

    harmonic balancer question(motor swap)

    Well I can say the 04 is in way better shape(200k vs 59k miles) and they are the same size only difference was the 04 had a bigger/thicker "plate" on the front of the pulley assuming can dampen more vibration cause of the extra weight maybe?
  14. paintballpyro1

    harmonic balancer question(motor swap)

    I'm in the middle of a 96 to 04 marquis swap and was wondering about the harmonic bal/crankshaft pulley. My squestion is which do i use? Use the 96 or use the marquis? The marquis has alittle more weight but other then that they are same about of ribs and everything and belt lines up no...
  15. paintballpyro1

    Engine engine swap, need some info

    Well got the plug out of the side of the block and ready for a temp sensor to go in but confused on which i need. when i did the intake swap on my stang couple years ago i broke the pass side temp sensor,bought a new 1 and then my gauge never work from then on. Im assuming they may have gave me...
  16. paintballpyro1

    Engine engine swap, need some info

    I've read that you can tap the coolant crossover since I have the metal one or remove a freeze plug in the side of the motor? What's up with the valley heater return line? I saw that it was a solid line instead of the rubber line on the mustang but they both go same place don't they? I haven't...
  17. paintballpyro1

    Engine engine swap, need some info

    I know this has been beat to death but some info i cant find. I just recently bought a 04 marquis motor for $400 with 60k on it. I plan on swapping it into my 96 which i have begun but noticed a few difference that im not sure about. I noticed that the new motor has 2 sensors in the valley, 1...
  18. paintballpyro1

    Engine Another romeo or windsor

    Well got the car with 52k and then put the rest on it. Served pretty well with how i drive it haha. It still runs and drives but ive replaced fuel filter,injectors,plug wires, spark plugs, coil packs and changed the tune back to stock and still cant get it running right so figured i got some...
  19. paintballpyro1

    Engine Another romeo or windsor

    Cool, so cams should be bolt on cam gear then? Im just excited that this year i have enough $$ saved to get my motor and cams soon. Its been a tease of only able to drive around the block but not the roads cause of the engine breaking up bad under load or above 3k but not bad for the 195k ive...
  20. paintballpyro1

    Engine Another romeo or windsor

    I have a 96 gt(x vin) just trying to figure out what motor i have as i keep reading conflicting info. I counted valve cover holes(11) would mean romeo but i also have read that the windsor came in for 96+ mustangs and romeo stopped in 95? Also ive been looking around for a used motor and have...
Top Bottom
Back
Forums
Menu