Search results

  1. jrc_03_gt

    what gears to get

    4.10's no doubt
  2. jrc_03_gt

    Bolt in subframe connectors

    :nice: :nice:
  3. jrc_03_gt

    What N/A bolt-on is proven to give the most WHP?

    GET THE 4.10's. :SNSign: :nice: :nice:
  4. jrc_03_gt

    75 mm throttle.

    make sure you use the gasket that came with the plenum for the EGR. Its thicher than the stock one and seals up much better.
  5. jrc_03_gt

    hand held tune or dyno tune??

    You can have a tuner do a custom tune on the dyno and then load it on to the predator.
  6. jrc_03_gt

    HP gain?????

    you will only get less than 10 horse power .
  7. jrc_03_gt

    Tranny Question

    Get a pro 5.0 shifter and be finished with it.
  8. jrc_03_gt

    hand held tune or dyno tune??

    Both. Buy a flasher/tuner and tweek it on the dyno. That way you know its safe and not too lean. You still can recalibrate for gear changes , off road exhaust and so on. :nice: :SNSign:
  9. jrc_03_gt

    Widest tire up front?

    I run 275/35/18 all the way around. no rubbing at all. I did however try to install an eibach anti-roll kit and the front swaybar rubbed the inside of the wheels. Im running 18"x9" wheels. Now I have the stock swaybars back in the car and no rubbing issues now.
  10. jrc_03_gt

    What else comes with Accufab/plenum combo?

    I think it came with a egr gasket too. If Im not mistaking the egr gasket it came with is thicker than the flimsy stock one. Mine did not want to seal up with the stock gasket. So I used the one from accufab.
  11. jrc_03_gt

    What else comes with Accufab/plenum combo?

    left over dust in your wallet
  12. jrc_03_gt

    91 octane with predator....problems!

    maybe octane booster would help? You can add it to your tank of gas each time. I dont know expensive it is though. Or just keep backing off the spark till it stops pinging. I run 94 in mine.
  13. jrc_03_gt

    Suspension Upgrade Question

    Check to see how much it lowers the car it may only be an inch or less.
  14. jrc_03_gt

    MM sub frames used as jacking rails?

    thanks guys.
  15. jrc_03_gt

    MM sub frames used as jacking rails?

    Can Maximum motorsports sub frames be used as jacking rails wihout denting or bending?????:shrug: :shrug:
  16. jrc_03_gt

    steeda says yes maximum motorsports said no...

    This is the question I have. Im puting on the eibach pro-system plus kit on my 03 gt which includes shocks struts springs and front and rear swaybars. Along with MM CC plates. I wanted to change out the rack bushings to get better steering response. So I did not know which ones to get steel...
  17. jrc_03_gt

    SAGGING EIBACHS??? GET IN HERE!

    do the pro kits sag??????????
  18. jrc_03_gt

    Throttle Body / Plenum Recommendations

    accufab. Dont expect huge gains no matter which one you buy. You will only gain a little in the upper rpm's. May not be worth it if you are looking for performace mods with big gains. The accufab looks like a million bucks though.
  19. jrc_03_gt

    Question on suspension upgrade

    coil over on a mustang :nono: :nono: :nono: call maximum motorsports see what they think.
  20. jrc_03_gt

    SAGGING EIBACHS??? GET IN HERE!

    does the pro kit sag too?
Top Bottom
Back
Forums
Menu