Search results

  1. J

    water wetter to be used with water only, no coolant?

    i have used it and still using it with 50/50...no issues
  2. J

    Wat does the PCV valve connect to?

    or it might go to the other end on the right side(standing at the front of the car) of the intake where the the other end of the hose goes
  3. J

    Wat does the PCV valve connect to?

    if i recall correctly it goes to the canister on the fender by the smog pump, you should see the other hose coming out of it
  4. J

    gas pedal question

    im not sure i never did it before....maybe some one else will chime in
  5. J

    wheel bearings / how much 2 port polish

    when ever i do the brakes, i buy new rotors so i just have to put the bearings and seal in and good to go instead of banging in and out races with a brass pipe
  6. J

    gas pedal question

    possible that the cable is shot or the springs on the throttle body need to be lubed
  7. J

    rear main seal question

    haha hissin, im hoping it comes out in 1 piece lol roughtly how much is the teflon seal? like 5 bucks? and does autozone carry them?
  8. J

    shifting

    have you recently installed a new shifter? if you have try adjusting the shift stop screws
  9. J

    PCV Plug/Hole Size?? On Lower Intake?

    id say half inch dont really remember
  10. J

    Aftermarket 28-splines

    im glad to hear that, because those are the axles i ordered when i ordered my whole rear assembly from brothers performance
  11. J

    rear main seal question

    is the rear main seal 1 or 2 piece for a 1988 5.0 5 speed T-5
  12. J

    Anyone with flowmaster part #'s???

    i read on here a while ago that flowmaster does not make the original 40 series any more just that delta flow crap
  13. J

    rear end install

    good thanks....any other info. i should know about
  14. J

    rear end install

    I just bought a FMS whole complete rear end assembly from Brothers Performance with 3.73 gears. Has any one had an experience with this installation before? Are there any fabrications I might need to do? Also, I got new axles too. Any one have a how to on them? Thanks
  15. J

    are quad shocks needed???

    it prevents wheel hop so i would leave them
  16. J

    Should I bother with Seafoam before new heads?

    it also cleans the top of pistons...but you could probably do that when u take the heads off anything, if anything dump some in the oil and the fuel
  17. J

    AMP light question

    i have a new battery with new cables and a new alternator. when ever i put the a/c on the amp light comes on, doesnt happen if i run the heat though. any suggestions?
  18. J

    Intake wont seal

    with the half inch spacer that i have on there now, it DOES rub on the hood which i do not like...so i might a new hood in the near future
  19. J

    Napa Fuel injector cleaner

    Sea-foam is the best...you can use it in the oil, gas, or through the vacum(sp?) theres a couple of threads on here about it so do a search
  20. J

    what stands out most about a fox body car?

    no1 mentioned listen for the 5.0 rumble...you can always tell a mustang from everything else
Top Bottom
Back
Forums
Menu