Search results

  1. T

    White Face Gauges

    Have you tried rearranging them or anything? I don't have any problems like that. -Will
  2. T

    How much faster in 1/4 mi with 4.10's?

    Well, I had a couple other mods, but from best I can tell, i gained close to half a second (thats right .5), but ONLY AFTER I learned how to launch and not spin so bad :) Also, MPG's aren't that bad at all. The worst part on gas mileage, is when you want to feel those new gears ;) -Will
  3. T

    GT Computer Swap

    If I were you, I'd contact SuperChips. They may be able to hel[p you, and they may also be able to help you if any tuning is required :) -Will
  4. T

    what do you think?

    Very well could be, if you rev in neutral, the rear end does nothing but sit there. I've been told that t-56's are a lil on the noisy side. You may wanna try and check all teh fluids throughout the car though :) -Will
  5. T

    Powerdyne supercharger news !!! 01-02GT kit

    I didn't know Powerdyne was coming out with anymore blowers past 1998 :confused: -Will
  6. T

    White Face Gauges

    Sounds to me like you didn't install them right or something. I have UPR El GLo gauges, and have got nothing but compliments wsince day one. -Will
  7. T

    Fuel filter changing question

    Yes, you can get the little plastic quick disconnects at any local auto parts store. Cardboard can work, but I wouldn't advise it ;) -Will
  8. T

    lost to an s2000...

    Either you can't drive, or there was more mods than you knew about. -Will
  9. T

    Where to mount gauges....

    I'd make sure that I could watch my fuel pressure at all times, if it EVER drops, switch off teh N2O right then. Maybe on steering column, a new cluster bezel, or where the 94-95 clocks are :) -Will
  10. T

    Will an X pipe make me run too rich?

    IF you get a midpipe with cats, then no, nothing is required. If you get an off-road, then you gotta get MIL's or a chip. -Will
  11. T

    New Hypertech Programmer!

    Hypertech worth 54 horses bone stock? I don't think so. If you really do have an 03-04 Cobra, I'd suggest a pulley, exhaust, CAI, or another sort of tune or programmer. -Will
  12. T

    4.10 in 1/4 went down help!

    What did you pull a 1.7 60' on!?!?!?!?!?! -Will
  13. T

    Which subframe connector

    My buddy got some off of E-bay, and they fit perfect. And [performed pretty good too. If you were lookin at budget though, I'd check out 50resto. -Will
  14. T

    Anybody have this X-pipe?

    You know better than to get cats ;) -Will
  15. T

    Anderson Powerpipe & Steeda Timing Adjuster Installed...impressions and questions

    IMHO, if you run 93 octane in it, 14* should be fine...... Also, make sure that all the sensors got hooked back up. Did, you reset the computer? It may help if you disconnected the battery for about 5-10 minutes, then started it up. That would help the car adjust to the extra flow...
  16. T

    Superchargers- Install and Forget or Nightmare?

    IMHO, the headswap would be less hassle from the way you seem to be talking :) -Will
  17. T

    Is Throttle Body Easy Installation?

    Seriously, its a piece of cake man :) -Will
  18. T

    Do fox springs ride smooth?

    I'd suggest H&R or Eibach. Never heard complaints out of either. Fox springs are more for those lookin for budget straight line from the best I know.... -Will
  19. T

    6.17 gears too much?

    You'd have been better off leaving the 4.10's outta your post. It would have been better ;) 3.73-3.27=.46 4.10-3.73=.37 Not even a full tenth difference in the 2. So, why would it matter to go from 3.27-3.73, and not be so much as to go to 4.10???? I switched 4.10's to 4.30's, and...
  20. T

    6.17 gears too much?

    Ignorance :rolleyes: And I love hows its "gonna have a Cobra motor in it", since the dang thing already has a DOHC. -Will
Top Bottom
Back
Forums
Menu