Search results

  1. geostang351

    H Pipe For 65 With AOD

    I would assume that the H=Pipe hits the tranny pan :shrug: ? If so, You'll need to fab something up. WHat I did was remove the pipes just before the mufflers, cut the pipes enough to allow the H-Pipe to slide rearward and weld a new piece to make up the difference at the collectors. Hope you...
  2. geostang351

    HELP- Dust in wet primer....

    I would let it dry, lightly sand it and reprime it
  3. geostang351

    EFI, Fox Brake Booster Question

    Need a magnifying glass to see it.
  4. geostang351

    Throttle cable

    Throttle cable? I believe it is a solid metal rod that attaches from your pedal assembly to the carb. Like this: :shrug: http://mustangsunlimited.com/itemdy01.asp?T1=69772+01&Category=&catkey=EMUSTANG
  5. geostang351

    1965 Mustang Hardtop Identification

    Sould be another VIN # on the passenger side inner fender UNDER the front fender. You'll need to remove the fender to see it.
  6. geostang351

    Sticky: I6 to V8 conversion

    :eek: :eek: You may want to price this around if this is the cost you're looking at.
  7. geostang351

    Wiring help needed!

    Run the wires in the front kick panels, under the sill plates, under the rear interior 1/4 panels (they are removed with I think three screws and yes you'll need to remove the rear seat to access them) then along the wheel wells in the trunk held in place by clips to the rear lights, again held...
  8. geostang351

    Wiring help needed!

    Two phillips head screws hold it in the firewall. The are diaginal from one another
  9. geostang351

    Gauges

    It's the brown rectangular part attached to the back of the large, right gauge. The gauges can;t handle the higher voltage of 12V so this "device" brings down the voltage to a useable level.
  10. geostang351

    heater box

    3M Spray adhesive
  11. geostang351

    Wiring help needed!

    It mounts along side the transmission
  12. geostang351

    Stock Alt, recommendations for Replacement

    I was refering to the year for the alternator.
  13. geostang351

    How do I plug the dip stick hole?

    I've heard that using a wooden dowl that is slightly tapered is the way to go. Tap it in with a hammer. The oil will swell the dowl making a nice seal.
  14. geostang351

    Front and rear window moulding clip?

    http://mustangsunlimited.com/itemdy01.asp?T1=8941+01&Category=&catkey=EMUSTANG