Search results

  1. S

    Steeda vs Magnaflow

    I ordered the Magnaflow today. 299+41 shipping. Too good a deal to pass up.
  2. S

    Steeda vs Magnaflow

    I am considering a Steeda or a Magnaflow Cat Back for my 04 Cobra. Any opinions? I do not want it to sound like a kids GT and to get dirty looks in traffic (unless I am doing something stupid). I do not want a drone at cruise. Deep clean sound yes, crackle pop, back off, no
  3. S

    2.93 vs 2.8

    I like the 2.8 with the idler pulley rather than the 2.93 with the no slip pulley. No dust, no slip, 1lb more boost.
  4. S

    2.93 vs 2.8

    I have a 2.93 with the so called non slip slots on my 04 and am not happy with the belt dust. I am going to add the Steeda Auxilary pulley and a std groove 2.93 or 2.8 pulley. What is your real world opinion on the pulley sizes? I will race the car occasionally so ET is important. I have the...
  5. S

    Steeda Tri Ax in 04

    I reinstalled the inner boot and it is now fine. Thanks
  6. S

    Anyone Replaced Just Mufflers?

    I am wondering about options as the stock mufflers are a bit strange as they are offset in and out on the same side. Why not just run straight through center in and out. This will require moving the pipes though also. The choice of muffler is somewhat limited with the stock muffler...
  7. S

    Need pics of IRS wrong bolt

    I have an 04 Cobra and would like pictires of which IRS bolt is supposed to be the 14mm instead of 12mm and hoe easy/hard the replacment would be. I am a bit confused looking under the car.
  8. S

    Steeda Tri Ax in 04

    I don't remeber a smaller piece of rubber. I will check it out.
  9. S

    Anyone Replaced Just Mufflers?

    I'm going with the Ravin Z55's. $169 installed (welded). The manager at a local Midas does great work, and while he is at it he will install my Steeda Diff busings for $20. What a way to spend a few hours on Sat, huh?
  10. S

    Anyone Replaced Just Mufflers?

    Has anyone just replaced the mufflers on an 03/04 instead of a cat back system?
  11. S

    Steeda Tri Ax in 04

    I installed a Steeda Tri Ax in my 04 and although it shifts great it is much noisier than I remember any shifter change I have done before. I have exerienced the typical (at least what I call it) on other cars when removing the stock rubber mounted lever, etc., but now I hear so much trans...
  12. S

    BBK 65mm 03 Cobra Port Matching

    I have a 65mm BBK TB for my 04 Cobra and would like to see how some users have port matched the intake to it. It looks like you need to radically port the intake pipe to match it, not a simple dremel type clean up.
  13. S

    BBK 65mm 03 Cobra Port Matching

    I have a 65mm BBK TB for my 04 Cobra and would like to see how some users have port matched the intake to it. It looks like you need to radically port the intake pipe to match it, not a simple dremel type clean up.
  14. S

    BBK 65mm 04 Cobra and idle hangs at 1500

    I have read some pretty impressive results with the TB replacement on the 03/04's. It was a Gift. I did not replace the stock one on my 01 L that made 500hp so I may tend to agree. It does seem that the Cobra turning more RPM may benifit at top end where the L did not. My L made peak power at...
  15. S

    BBK 65mm 04 Cobra and idle hangs at 1500

    I installed a 65mm BBK throttle body on my 04 Cobra and it runs fine except the idle hands at 1500. If I blip t6he throttle it goes down to 1000 and then slowly drops to 750. I have set the TPS from .82 to .98 and adjusted the throttle stop as BBK recommends (listed below) and looser to no...
  16. S

    BBK 65mm 04 Cobra and idle hangs at 1500

    I installed a 65mm BBK throttle body on my 04 Cobra and it runs fine except the idle hands at 1500. If I blip t6he throttle it goes down to 1000 and then slowly drops to 750. I have set the TPS from .82 to .98 and adjusted the throttle stop as BBK recommends (listed below) and looser to no...
  17. S

    03/04 Wheel Hop Fixes

    I have an 04 and even with only 200 miles I have felt partial throttle wheel hop. (the ground is so cold I cannot get any traction as it has been between 10 and 20 degrees for almost 2 weeks now) I have been considering the RPM rear diff support. Does anyone have any experience dealing with the...
  18. S

    Does 03/04 really need shifter?

    I have a new 04 Cobra with 200 miles on it covered in snow and the weather has sucked for 2 weeks now so I am not likely to drive it soon. (I am lucky to have an 04 Expedition). My 97 Cobra had a junk shifter. At 20000 miles the trans jumped out of 2nd. Is the stock Cobra shifter on the T56...
View older results
Top Bottom
Back
Forums
Menu