Search results
-
-
-
-
-
-
-
-
-
-
My Mustangs
- XLR8TR
- Album
- Comments: 0
-
Blown a plug :shock:
Had the same thing happen to me on my '01 GT with 103k on the motor. Cost me 500.00 at the Ford dealer to put in a Time-Sert, and it runs fine now. It's sad that I don't really trust it though, I mean, if one hole went bad, whats the odds of another one doing the same thing? Might be time to...- XLR8TR
- Post #43
- Forum: SN95 4.6L Mustang Tech
-
Oil in EGR Passage
When the intake is in place on the engine, there is a hole that is located right under the intake EGR passage at the back of the engine. The hole is there from when the oil gallies were drilled into the block during the manufacturing process. Check to make sure the freeze plug that was...- XLR8TR
- Post #3
- Forum: Fox 5.0 Mustang Tech
-
alternator bracket bolts keep snapping
Oh man...the same thing happened to me! I have the same setup (GT40p heads, no smog pump, and a 3g alternator) and have been running it for a few years now. Then last month I was just cruising along and smelled burnt rubber, stopped, and found the alternator and bracket hanging down at an...- XLR8TR
- Post #9
- Forum: Fox 5.0 Mustang Tech
-
Where to buy sleeves for mounting Steering rack
If the steering rack bushings are worn, would the car be making a "clunk" noise when going over bumps in the road and stuff? Sounds like its coming from the front center and I can feel it in the steering wheel some.- XLR8TR
- Post #5
- Forum: Fox 5.0 Mustang Tech
-
Tilt steering column conversion!
friend didn't get the picture for me...if you want to I'll describe it for you, just let me know.- XLR8TR
- Post #15
- Forum: Fox 5.0 Mustang Tech
-
Tilt steering column conversion!
Yea, there was a space open, my friend is coming by tomorrow with his digicam and I'm gonna snap some shots of my 'stang. I'll take a pic of the steering wheel and explain what I did. Probably be Monday by the time he gets the pics uploaded and sent to me. I really need to go buy a digicam!!- XLR8TR
- Post #13
- Forum: Fox 5.0 Mustang Tech
-
Tilt steering column conversion!
steering swap. The units were almost identical, but you'll lose the airbag. I swapped the electrical junctions from the 92 column to the 87 and checked the hookups to make sure it was all cool. Lost the cruise also, but the harness for that is where I can get to it so I might do a setup for...- XLR8TR
- Post #11
- Forum: Fox 5.0 Mustang Tech
-
installed stage 1 cam, car is going crazy!
When I did a cam swap, of course the battery was disconnected. After everything was done, I was told to go drive the car as I normally would for at least 15 minutes so the computer could learn the new parameters of the cam. I also heard that to cure some computer related problems, disconnect...- XLR8TR
- Post #4
- Forum: Fox 5.0 Mustang Tech
-
Starter Relay
Simple request. Does anyone have a good picture of the starter relay showing the wire and cable hookups? I tagged them but the tags fell off. Or tell me if I'm right...the starter cable goes to the post closest to the battery, and all the other wires/cables (that are hot) go to the post...- XLR8TR
- Thread
- Replies: 2
- Forum: Fox 5.0 Mustang Tech
-
99-04 front & rear springs on FOX body?
Springs I remember reading that someone fitted his 'stang with FRPP springs that belong on the Bullitt Mustang. Might contact a Ford dealer and talk to him. I wrote down the part numbers, but my organizational skills are lacking. So it seems to me that if they fit, the other springs should...- XLR8TR
- Post #6
- Forum: Fox 5.0 Mustang Tech