Search results

  1. S

    coolant overflow problem???AHHHHH???

    :shrug:
  2. S

    Quick! header to h pipe. what size nut?

    7/16"
  3. S

    Avenger power pipe/elbow sold at???

    :shrug: You don't mean the C&L one do you?
  4. S

    coolant overflow problem???AHHHHH???

    Actually, my thoughts were that the t-stat was in backwards......
  5. S

    coolant overflow problem???AHHHHH???

    Dumb question. Have you tried changing the thermostat? Along that line, what's the temp. gauge act like?
  6. S

    vibration after clutch install (foxbody)

    Either the trans mount (doubt it) or the flywheel isn't balanced correctly.
  7. S

    TB Question

    Agreed as previously stated. 70MM is too big for basically stock applications. I didn't upgrade to a 70 until the blower went on.
  8. S

    any tips on painting 10 holes and faded door/mirror area?

    Our local Napa store sells a specific black "bumper paint" to imitate the factory black look. Not dull but not glossy either. Just right if you ask me. Regarding the wheels, make sure the paint is an engine paint so it'll stick to the aluminum, or try eastwood for some wheel paint.....
  9. S

    Anyone know of a good company for powdercoating (chrome)

    Try Prism Powdercoating in PA, they did my upper intake in "cerma-krome". http://www.prismpowdercoat.com/cermakrome.html
  10. S

    pilot bearing #?

    If memory serves me correctly, the manufacturer/make was for a volvo, but I can't remember which model. TTT for ya...
  11. S

    odd occurence last night

    Either a loose connection at the speedometer speed sensor or speedometer head or the speedometer head is getting ready to go south for retirement....
  12. S

    help with Ground Wires

    Don't forget about the ground wire behind the battery on the inner fender.
  13. S

    Boost Guage

    I spliced mine into the vac. line that feeds the f.m.u.
  14. S

    Ujoint will not fit into new yoke.

    Ah, then perhaps 5.0 Resto messed up. Regardless, if you take the u-joint back, you can get one that fits your yoke and driveshaft. They may have to do some digging around to help you, but it can be done.
  15. S

    Ujoint will not fit into new yoke.

    Sounds like you got the wrong u-joint....
  16. S

    roll bar sleeves

    here's a thought, try a bike shop for those snap together covers that go over the center section of the handle bars...
  17. S

    transmission

    Not too difficult, just be prepared to get covered in tranny fluid unless you drain it first. Use a screwdriver to pry the old seal out and then grab a socket that fits over the seal portion so it seats on the outer metal ring of the seal, and gently use a hammer to evenly drive the seal in.
  18. S

    whats up with my trannsmission

    Either your shifter isn't adjusted correcty, or you've bent a shift fork, or you've chewed some teeth off over the years....
  19. S

    Had alot of fun driving stick

    Yep, 5 spds are :nice:
  20. S

    BBK CAI knocking against shock towner

    It's not uncommon for the BBK pipe from the throttle body to mass air sensor to require @ 3/4" to be cut off. Or, try shoving it closer to the throttle body inside the rubber coupling, or even check your motor mounts, especially since the engine torques from right to left.....
View older results
Top Bottom
Back
Forums
Menu