Search results

  1. Matt90GT

    parts list for 5-lug conversion please!

    http://svo73mm.cjb.net check the bottom of the 5 lug page.
  2. Matt90GT

    Brake parts ?

    The T is not hard to find. It is the SAE to metric fitting that is really not available.
  3. Matt90GT

    anybody have any problem's passing visual part of inspection without smog pump???

    The cats dont care about the air. What you are doing is diluting your exhuast with fresh air to "lower" the emissions. Old try, just like watering down your drink at the bar!
  4. Matt90GT

    Kaase Heads

    check the latest or last month of Popular HotRoding magazine. it is the one with the red fox body mustang on the cover with bullit wheels. They did a build up on a stock 89 shortblock with 100K miles. Impressive numbers. with a cam, 750 carb, victor intake at 7800 RPM got 500hp. But...
  5. Matt90GT

    5 lug conversion question?

    You get what you pay for. The $200 kit only gives you one extra lug at each wheel. No braking improvements and limits your wheel selection. The 1800 kit will make your car stop as fast as a 911. and you can use most all OEM wheels.
  6. Matt90GT

    re-engineering the brake pedal

    A PV is ONLY for the rear brakes by definition. If you have to use one up front, something is ****ed! Get the mathis Mustang 2 book. The modifications are explained in there.
  7. Matt90GT

    turbocoupe rear in stang?

    Dude, NorthRaceCar brackets! that is all I have to say about that! http://www.northracecars.com
  8. Matt90GT

    Anyone got pictures of "Billet" Pieces in there interior? Post them here!

    LOL! That is a pic like at the seat height, so you dont see that when sitting or looking in the car. But that bungee is the only way I have been able to reliably keep the cover on there! Stupid design! Dont knock it, it works! :D
  9. Matt90GT

    My e-brake light doesn't turn on.

    black is ground. jumper the other 2 to the ground to figure out which one it is. Also check the dash light. you should be able to turn the key to ON with the handle up and then jumper it a few times to figure out which one trips the light. It has been a while.
  10. Matt90GT

    Anyone got pictures of "Billet" Pieces in there interior? Post them here!

    You can get them anywhere. just look for them. The dead pedal is a replacement, you use the stock L bracket there. pop off and then on with the new one with the clips on the back side. The throttle is a splined pin arrangement through the shaft of the throttle assembly. Press off...
  11. Matt90GT

    Top K-Member and A-Arm and Coil Conv. shootout

    HAL does also. About 3/4" gain to the wheelbase. So does the D&D on a 87-93 V8 , but negatively!!!! You lose about 1-2" of front track.
  12. Matt90GT

    Anyone got pictures of "Billet" Pieces in there interior? Post them here!

    Here is a quick shot after I got the bullet pedals installed in the 90GT: <img src="http://mjbobbitt.home.comcast.net/mustang/interior/pedals.jpg"> This is not a direct swap. the dead pedal and accel pedal went in fine. the clutch and brake pedals had to be ground down to accept them...
  13. Matt90GT

    Brake kits shootout

    Call MM or Griggs. They will help you make your decision as they both sponsor and sell parts for the majority of the AI AIX cars. For the c5 vette calipers, they are not the same as the cobras. The cobras have the holes cause that is how the caliper is retained to the car. You remove the...
  14. Matt90GT

    Diversifies Products Marketing. Good or BAD?

    good place
  15. Matt90GT

    Brake kits shootout

    Which Corvette calipers? The new C5 calipers are WAY different than any mustang PBR calipers. Check with http://www.corner-carvers.com for more people with real world OT experience with the different kits. Right now, the stop tech with the HUGE mono block caliper is what the AIX cars...
  16. Matt90GT

    My e-brake light doesn't turn on.

    Yes! Since you do not have the low fluid sensor plugged in, the circuit will not complete. YOu need to jumper wires 2&3 if I remember correctly. Then the dash light will work again with the handle. ANother reason you should not use the SVO unit on the car. THe SN95 units are a better...
  17. Matt90GT

    My e-brake light doesn't turn on.

    Be sure that you have the low fluid sensor plug in at the master cylinder under the hood.
  18. Matt90GT

    mm brake upgrade kit

    Also be sure you did not install the calipers on the wrong side! If you do, you will never be able to bleed them right mounted. The fitting should be facing like this: Common installation error with the stock and 73mm calipers.
  19. Matt90GT

    installed stage 1 cam, now car is f'd!!

    I was kind of thinking along the same lines when I first started reading. Did you install the plugs to the HO firing order? The car will run, but shake violently if you install the plug wires on the non-HO firing order or if you just have 2 on the wrong plugs.
  20. Matt90GT

    installed stage 1 cam, now car is f'd!!

    A A9L is a A9L. No others ECU codes will be the same as the A9L. Who's line of bull did you buy there?
Top Bottom
Back
Forums
Menu