Search results

  1. jpplaw

    about to make some MIL eliminators...

    Think I need to try this too. The doubled-up anti-foulers aren't working for me
  2. jpplaw

    Mil eliminators

    Not sure what the thread size was but I ordered 2 sets of them from here: 02 Sensor Raiser Non Fouler Mustang 05+
  3. jpplaw

    Mil eliminators

    You can't turn them off with a handheld SCT tuner. They can be turned off in the tune though. If Michigan uses the OBDII test for inspection, you will not pass if they are turned off. Get some anti-foulers. Use 4 of them, 2 on each converter. Drill out one of each pair. They will move the O2 out...
  4. jpplaw

    The Squeaky Wheel

    Though probably not likely, I once had a right rear tpms come loose and start making some funny noises I couldn't quite track down. Then after awhile it let go completely and started banging around inside the tire. Eventually it stopped working completely and the warning light came on, thats how...
  5. jpplaw

    The Squeaky Wheel

    Bearing is the next most likely culprit. Have the axle pulled and get it checked out. A bad bearing can be dangerous, it can chew into the axle itself. If that happens, a good bump can snap the axle. Is it a constant squeak? Intermittent? Rhythmic?
  6. jpplaw

    Bolt-in Speaker replacements?

    Check out crutchfield. I got some JL Audio 6x8's that bolted right in.
  7. jpplaw

    Tuning for 05 Mustang GT

    What kind of handheld tuner do you have? Most of the good tuning shops use SCT. If you have an SCT handheld there are plenty of tuning shops out there. Brenspeed, AM/Bama, etc. I use Brenspeed myself, never had a problem. Any of the above shops can hook you up with an email tune. CMCV delete is...
  8. jpplaw

    Ruined my GT

    +1 to the Koni STR.T's. Good ride, good handling, good price.
  9. jpplaw

    New hood on a 2006 GT, now engine is running lean

    Its not the volume or temp of the air that is the problem - it is the turbulence. Aim a car dryer or leaf blower at the CAI with the car running. It will cause the same problem. The MAF needs a steady smooth supply of air to read correctly. Thats why a tune can't really compensate.
  10. jpplaw

    Signal light question

    The computer can make it do that. Unhook your battery, that will reset it.
  11. jpplaw

    Shaker 500....

    Don't be surprised when your door subs don't put out the volume anymore if you change them out. The stock subs are like 1.2 ohms. After market subs are anywhere from 2 - 4 ohms and work best if you use an amp other than the stock shaker 500 amps.
  12. jpplaw

    Car running very rich for no reason!

    Injector(s) leaking or stuck open? Can you datalog fuel pressure (drop) and fuel pump duty cycle (fpdc) ?
  13. jpplaw

    Ford Racing SVT Front Brake Upgrade Kit (05-12 GT)

    I put the kit on my 09 GT. Its an easy install and the performance is great. Stops on a dime. I put some Hawk ceramic pads in at the same time. I painted my calipers blue and stenciled the Brembo back on in orange. Be aware that most stock wheels will not fit over the Brembo calipers - I have...
  14. jpplaw

    Edelbrock vs. Ford Racing Supercharger

    I have an E-Force on my 2009. Installed it myself. I am running a Brenspeed Stage 1 kit, which uses a 3.5" pulley (7-9 lbs boost). I am using GT500 fuel pumps also. Pulls like a freight train, Its been on for over 20k miles and 2 weeks ago just dyno'ed at 474.55 rwhp, 434 rwtq (I do have...
  15. jpplaw

    car idle is off after replacing the battery???

    It needs to re-learn the idle settings. Idle it for like 10 minutes without touching any pedals, then another few with the a/c on without touching any pedals
  16. jpplaw

    2005 Stang - Replace the built-in sound

    Check out crutchfield.com. They lots of good stuff, I got most of my system from there. Also check out championmustang.com - they carry the shelby audio upgrade package and components. I got my 8" door subs from there.
  17. jpplaw

    the infamous "cam position sensor" code NEED HELP!!!

    Probably a bad alternator
  18. jpplaw

    Brake pads question

    Hawk ceramic pads are good too. They don't make as much brake dust but I have heard they can be hard on rotors.
  19. jpplaw

    Slightly Rough Idle

    Is the roughness something new? Or did it always do it? The stock cams are ground for torque, and are actually pretty darn good. However, they do not idle perfectly smooth even when there is nothing wrong. There is a very slight cam lope even when stock.
  20. jpplaw

    Need help with part I.D.

    Try CJ Pony Parts. I know they carry the splash shields
Top Bottom
Back
Forums
Menu