Search results

  1. S

    new to site

    I have always been fond of 3.73 gears. Also hear lots of good things about 3.55 too. Maybe i am wrong here but anything higher might not be for what you want.
  2. S

    Car won't idle

    its still fuel injected. The fuel seems to be fine. I got a tune from JMS and gave them the cam an the number an all that ****.
  3. S

    Car won't idle

    oh the block i used wasn't out of a 94 mustang. It was a old truck 302. It wasn't a roller block.
  4. S

    Car won't idle

    Yup that was the firing order i used. I didn't use stock push rods, i got push rods that matched what i had.
  5. S

    Car won't idle

    Will have to post it tomorrow because the card is with my car in my step dads garage. It seemed to run good today when we changed the timing. What is the worst that can happen with that cam. I am asking being i really don't know. Because i have a flat tappet cam an lifters. I would think if i...
  6. S

    Car won't idle

    Since 94 mustangs are roller and i put in a Flat Tappet what does that mean. I am lost now. Should i just buy a roller cam and lifter set or will what i have be fine for right now. I guess i don't know what you mean. as far as the firing order, I believe i had it at the one...
  7. S

    Car won't idle

    i typed in the part number on the receipt from summit and this is what they gave me. COMP Cams CL31-246-3 - COMP Cams Xtreme Energy Cam and Lifter Kits - Overview - SummitRacing.com
  8. S

    Car won't idle

    As far as i know i do, its for a 94 Mustang 302. I've seen some people have surging issues on this website an mine sounds a lot like some of those problems, the rpm jumps when its under 1500, doesn't jump unless its under 1500rpm
  9. S

    Car won't idle

    i was going to pull it, but then right before we figured out the problem. For some odd reason my firing order was different then stock. The Cam sheet had a new firing order, changed the order, the plugs, put gas in an when i turned it over gave it some gas started right up. Still idling...
  10. S

    Car won't idle

    I plan on doing that anyway, but right now i am trying to figure out what the hell is causing my problems.
  11. S

    Car won't idle

    Why would i do that. I am asking because i don't know. My intake is not stock, its a typhoon intake. Where would i look, what do i look for. I am open to any an all suggestions. My car won't start without holding the gas down, can't get it to idle, my plugs are blacker then poo, an it...
  12. S

    Car won't idle

    I will try that tomorrow because i really don't know what to do. My plugs are blacker then hell, have went threw 2 sets of plugs within 10 minutes of the car being on and or trying to be started. If its not the chip the only thing i can think of would be a bad vacuum leak. Since i...
  13. S

    Car won't idle

    Is it possible the Chip i got from JMS is causing the problems. Maybe i put it in wrong, or the chip was tuned wrong or something. Toyman i am slow at times, i didn't understand what you meant by pull the chip
  14. S

    Car won't idle

    its not a butt load, but enough to smell it an cause some issues. We have checked an check an rechecked an redid everything with the distributor Why would i want to pull the chip, i had it programed to my settings.
  15. S

    Car won't idle

    after hours an hours with the car tonight im to the end where i just really want to sell the car, its pissing me off that bad. New plugs an again ruined. The car is also getting to much fuel. Can't get it to idle, stay running, an to much fuel, what the hell is the problem.
  16. S

    Car won't idle

    My step dad said it was on the compression stroke. He checked it a few times, with the number 1 cylinder. He could be wrong its possible, but not likely. For this instance lets say he is correct. everything installed. GT-40 Aluminum Heads - Ported Typhoon intake Ported Granatelli MAF...
  17. S

    Car won't idle

    My car won't idle. The timing is on 10 right now and im sure of it. But it won't freaking idle. It dies at 1,000 rpm. It back fires, an i have fouled 2 sets of plugs. It sucks because i have been working on it for 2 months an finally get it to start, but i have to hold the gas down because...
  18. S

    Replacing Fuel Pump

    i finally got it last night, it was a pain in the ass. For some reason it just didn't want to go in. The worst part was when taking the tank down, one of the bolts stripped coming out. Oh boy was that a treat getting that out.
  19. S

    Replacing Fuel Pump

    I started to change my fuel pump today an it was a nightmare. One of the bolts stripped that was holding the gas tank in, so i had to drill that out. Then i couldn't get the fuel lines off an that was a nightmare. Finally got the fuel pump changed to a Trick Flow 255, but can't get it back in an...
  20. S

    please help car won't start

    Thanks, it really helped. I changed the thing off my intake an put it on my adapter like you have it. hooked up the fpr and ran the bigger one to the tree. I also realized i don't need any of the red green or any of those color lines since i deleted all my egr an smog stuff out of the car...
Top Bottom
Back
Forums
Menu