Search results

  1. 8

    Pulling A Head

    Anyone know if I can pull a head off a 95 gt ,with the stock header still bolted to the head? thanks I think a head gasket let go
  2. 8

    Heater Sometimes Blows Cold, No Reasone

    I think I found it, and you were right, [leak]--- Press test again and found a small leak at the water pump gasket ,and timing cover gasket. All seems good now on first test drive after the fix, we will see
  3. 8

    Heater Sometimes Blows Cold, No Reasone

    Update, I put my pressure tester on it, and DID NOT SEE any LEAK, or drip under the car. So I tightened the hose clamps and put a new thermostate in and rad cap. I will try it out
  4. 8

    Gasket Sealer

    Is it ok to use gasket sealer in the cold? thanks
  5. 8

    Gasket Sealer

    Is it ok to use gasket sealer in the cold? I do have a space heater,but I cant keep it warm long permatex grey
  6. 8

    Heater Sometimes Blows Cold, No Reasone

    it also kinda acts like, if the heater is on to high, it cools down the coolant and shuts off the thermostat. I will check somemore latter
  7. 8

    Heater Sometimes Blows Cold, No Reasone

    I will check, but it does blow hot air, just sometimes not---[ when it should], like it is low on antifreez, but its not
  8. 8

    Heater Sometimes Blows Cold, No Reasone

    Sometimes my heater will blow cold, if I mess with the switch I can get it to throw heat. I have already looked at the small vac line on the firewall---ok I have already checked the fluid leavel----ok thanks
  9. 8

    Lifespan of 5.0L engine?

    I have a 95gt with 356.000, never had a valve cover or oil pan off, orig timming chain too. We bought it with 18.000 mile. never drove it hard, just a daily driver, car saved us a ton of money still drive it every day
  10. 8

    Need Help With Finding The Right Converter

    yank ?
  11. 8

    Need Help With Finding The Right Converter

    yes ,I did call PTC, they seem like good people ,like Edge and yes my power band is a little higher with the sc, it falls off after 5800 Edge says they take the max horsepower and take away 2500, and thats is your stall, PTC said about 3400 would be good ultimate converter said...
  12. 8

    Need Help With Finding The Right Converter

    I told them all the-[exact]- same thing , that it would be a street and strip car ,50/50 , just like that This is what Jegs/Summit look at, my cam stage 1 trick flow, says its power band is from 2000 to 5500
  13. 8

    Need Help With Finding The Right Converter

    That is what they say at Jegs and Summit,-- [2500] but when I call precsion, edge, or Ultimate converters, they add about 1000 more to it or more
  14. 8

    Need Help With Finding The Right Converter

    Thanks, Im getting good help C-4 trani
  15. 8

    Need Help With Finding The Right Converter

    To start with TCI and B&M said ,I need 2500,converter The car is an 89 mustang , with a 302 HCI , 10psi of vortech, 373 gear c-4 , 25 inch tire The cam is a trick flow stage -1 ---- 221 dur on the intake and 225 exh, with about 530-intake lift and 540 exh lift with 1.72 rockers What do you...
  16. 8

    Need C4 Help

    It has a 5speed now, I just dont go to far away in it. The dragstrip is like 25 min away at 55mph I have 450hp to the tire, I just dont know what to buy ,or where to buy it
  17. 8

    Need C4 Help

    thanks
  18. 8

    Need C4 Help

    thanks, How much do I need to spend, to have one done? or should I just order one from some place?
  19. 8

    Need C4 Help

    Im thinking about going to a c4 automatic in my 89lx It has HCI and a vortech with 10 pounds of boost, Will a stock c4 with a reverse valve body be ok? Thanks!!!
  20. 8

    Power Window

    Just replaced my power window motor, and [now] the window drags some, going up, near the top? anyone have any ideas? thanks
Top Bottom
Back
Forums
Menu