Search results

  1. tdaily2

    Bad brake problem

    it may be the valve to the from brakes
  2. tdaily2

    Rear discs

    yea you will have a problem with the tires rubing the body if you do not bind the lips
  3. tdaily2

    Bad brake problem

    are both sides or is it just one side if it just one then put a new caliper on and that will fix the problem but if it both may need a new master for it
  4. tdaily2

    t5 swap questions-wiring

    the plug to the trans goes under the carpet and pluges inall you have to do is move the carpet from the driver floor and you will see it runing from the trans and there is a plug the wire is not but about 2' long it is better then cutting the wire and then having water to get into it
  5. tdaily2

    brakes

    where is the squeeling form front or back
  6. tdaily2

    need some advice on intake

    get teh pi save some money on other things for the car
  7. tdaily2

    Fuel Filter Location

    pull the fuel pump fuse and run the car and will make it easy
  8. tdaily2

    Aluminim Flywheel

    and look at the join date
  9. tdaily2

    The SN65 project car

    :cheers: i have to say hands down this is one of the best car builds that i have seen
  10. tdaily2

    magnapacks + ___-pipe...?

    i will get a sound clip of it this week
  11. tdaily2

    Paint Code for "Anthracite"

    per ford they are charcoal gray for the 03/04 part # m-1007-j178
  12. tdaily2

    Aluminim Flywheel

    it is less rotating mass and that takes off stress on the back of the motor and it will rev faster it is like putting 20's on a car and keeping the stock brakes and will take longer for the car to stop
  13. tdaily2

    Paint Code for "Anthracite"

    dsg is to dark i have a 04 and they are not close to the dsg
  14. tdaily2

    magnapacks + ___-pipe...?

    i have the Prochamber with magnapacks and mac lt and it sounds so good i would not change a thing
  15. tdaily2

    Need install help...

    go sears and get a ratchet wrench and it will help and you will need to move the motor to the driver side one thing make sure to put the driver side on last so you will be able to move the motor over the few inches you will need
  16. tdaily2

    Need install help...

    it is not bad you will be ok to do what the like adv to do this i have put a set in with out taking the motor out and was a pain. but lifting the motor up just make sure to use the 2x4 :cheers:
  17. tdaily2

    No X PLAN for GT Mustangs

    the dlr does not have to sell a car at x or a pins that is up to the dlr.
  18. tdaily2

    finally starting my build up, have some questions

    5.0L "CAMMER" MODULAR CRATE ENGINE ASSEMBLY 14,995.00
  19. tdaily2

    X-plan pin?

    yes ford emp can give out pins we are only given so many a year. and yes they are tied to the person ssn# name and the add.
  20. tdaily2

    Overheating....What is it?

    you say you flushed the sys? did you put a new t stat in. if not sounds to be the t-stat it is cheap to fix so start there. it could have air in the sys but if you flush the sys then best to put a new t-stat in.
Top Bottom
Back
Forums
Menu