Search results

  1. 2

    95 cobra , code 564 , help ?

    Let me know what yours turns out to be
  2. 2

    95 cobra , code 564 , help ?

    60 amp fuse is good and I have power at the CCRM on the pins that the power feeds to , checked all fuses inside the car and under the hood
  3. 2

    95 cobra , code 564 , help ?

    I have done pinpoint test and I get to a point where its telling me to replace PCM , well I did that and guess what , still no fan , all wiring between PCM and CCRM is good , CCRM is new , PCM is new well (remanufactured) I run pinpoint test with new PCM and says replace PCM , what are the...
  4. 2

    My car is missing real bad........ why?

    CE light on ? If so get autozone to scan the codes and post results , that will help us help you , where are you at in NC by the way ? Welcome to stangnet
  5. 2

    why can't I get rid of this SES light?

    Post the P codes , unless your MIL eliminators are faulty they should keep the codes off
  6. 2

    For those with built rear ends ;)

    If the Eatons were a $1000 bucks Id still buy it , Ive had one , you cant get anything better IMO ....
  7. 2

    SCT Eliminator Chip, Can any dyno tune shop re-tune?

    Quarterhorse all day long
  8. 2

    Tuning/Tweecing the 4.6

    play with the dashpot settings to adjust the speed the idle falls , be careful though if it falls too fast it may cause it to stall , and do you have a good steady 14.7 air/fuel at idle and cruise ?
  9. 2

    Auto to manual swap - ECU wiring harness the same? Also SF3/ECU questions...

    would take too much time to type it all , basically call your tuner and ask him what he would prefer you do
  10. 2

    Auto to manual swap - ECU wiring harness the same? Also SF3/ECU questions...

    most likely the strategy of the other ECU will be different so your current tune would not even work, it would be just as simple to get a new tune for manual swap with your current ECU , probably be less work for your tuner to just go in and change those particular trans switches off
  11. 2

    Looking for CVAE6 bin

    What are you using to tune with?
  12. 2

    Differential & axles: Strange vs Mosler vs FRPP

    Ford Racing all the way , not terribly expensive , and use stock wheel studs which you will thank me later for when you break one and are out of town and cant wait for summit to order Moser replacements , Ive never used Strange they were always higher priced Superior axles suck on 99-04 cars...
  13. 2

    96 Gt not starting?

    check fuses and grounds to PCM , sounds like the injectors are spraying for some reason , is the theft light blinking when you are trying to start it ?
  14. 2

    New 2003 cobra acting like ****box

    Have you called the shop back ?
  15. 2

    SCT tune on a 95 cobra question..

    3 year old post
  16. 2

    Engine holding back at WOT

    First post fail
  17. 2

    2004 Saleen, OEM supercharger?

    I would call Saleen directly and ask if they have a rebuilder they recommend or if they do it in house , not sure , or you could watch Ebay for used units
  18. 2

    Swapped 02 2v in my 89 coupe....need elec schematics

    Smart remarks will get you even less help , go to alldata.com and pay for a subscription and print wiring diagrams all you want
  19. 2

    Dorman Intake Manifold

    Sure you had the right part number Dorman on it to begin with?
  20. 2

    Diablo issue..

    what do you mean soldered? the pins in the OBD2 plug should run into a wiring harness and all the way to the PCM , can you post a pic up ?
Top Bottom
Back
Forums
Menu