Search results

  1. dgollem

    Semi gloss? Old what is it?

    A good glaze might shine it up, not as harsh as rubbing compound
  2. dgollem

    Painted trim...ugh

    Sand and paint;)
  3. dgollem

    '89 GT Upper Intake Leak - Pics (HELP!)

    Plus 1 for are you sure its leaking? When is the last time you cleaned that area off. Some purple power or simple green and a garden hose should get most of that residue off . Then if it comes back in a short time I would worry about leaks. There really is no oil of fuel flowing thru that...
  4. dgollem

    Might sell the '86 for an '04 Cobra

    keep the 86 and buy the cobra, its only money:) thats how I ended up with two
  5. dgollem

    I need help, nobody can answer this!! Im rarely stumped!

    I'm a little confused, you have a speed density computer/wire harness on a 97 mass air motor?
  6. dgollem

    frpp crate install

    Looks good, Where in MD are you?
  7. dgollem

    4 eye pictures wanted

    Its the Ford MK 2300 kit
  8. dgollem

    4 eye pictures wanted

    I like Black :)
  9. dgollem

    I need encouragement

    It is a Cervinis Stromin Norman hood
  10. dgollem

    I need encouragement

    My 85 before during and after
  11. dgollem

    I need encouragement

    You get what you work for,:hail: especially when starting a project on an older car. No rust is key factor, good engine and trans help a lot. Cosmetic work can be done with little money and lot of elbow grease. I have painted several cars in my own garage for $500.00 or less. Not show...
  12. dgollem

    Preparing a 92GT for a 4,000 mile drive

    If they are still on your car, remove the fog lights for the drive. Lots of gravel on the ALCAN and I would bet the fog lights wont survie the trip. Put them back on once you get there. Easy way to save some money. If your paint is good might also want to put a bra on for the trip. The car...
  13. dgollem

    strut tower ..is this a high quote??

    Quote sounds high to me but look at from their side (not defending just trying to ratioanlize) $100 bucks and hour labor, 30 or 40 hours maybe need to pull the engine to gain correct access. They will have to make sure its fixed right if it breaks while your driving then they have liability...
  14. dgollem

    Welding on an EFI Cars and sub frame connector ground clearance

    I have MM sub frames on a lowered car (the black one) and no scraping even over speed bumps.
  15. dgollem

    HELP!! My ignition system is outfoxing me

    PIP, its cheap but have to pull and disassemble the dizzy to change. Not really hard if you have a vise to hold it while you drive out the roll pin and gear off the shaft. TFI modules can act weird too. Easier to change but cost more. Both can cause intermittant problems
  16. dgollem

    heres my pics as promised

    Looks Nice:flag:
  17. dgollem

    touchy steering

    The shimmy is probably cuased by out of balance tires. You can rotate front to rear and see if the shimmy changes or get everything rebalanced if it bothers you. Over time it may cause some cupping and increase wear but only if you drive a lot at the speed where the shimmy is.
  18. dgollem

    Running a breather instead of a oil filler cap, yea or nay?

    I have breather on my 86, never noticed any problems
  19. dgollem

    AC Relay Help-any help GREATLY appreciated

    Is the low pressure switch connected. It is on top of the drier on the fire wall, passenger side. Search AC r 12 -r134 conversions here and you should find a picture
  20. dgollem

    Something alarming... maybe

    Don't plug it, it is there for condensation to drain from the ac evaporator. your leak looks green like anti freeze so its gotta be the heater core. If you don't fix it you will want to by pass it under the hood so you don't keep losing coolant.
Top Bottom
Back
Forums
Menu