Search results

  1. 03ghoststang

    alignment question

    you use nearly the same setting i use :nice: ...... I also get alot of pulling complaints road test the car and like you said steering wheel is crooked with my C/C plates and keep in mind iam at stock height......R/F @4.5* .......L/[email protected]*
  2. 03ghoststang

    alignment question

    i have :stupid:
  3. 03ghoststang

    alignment question

    sometimes our stock caster camber plates already come maxed out in certain cars and the cmaber will still be all screwed up, just get the C/C plates......where i work at i suggest them to most mustangs that come lowered but they're like no its too much. Then i try and set there alignment to get...
  4. 03ghoststang

    19.5 Volts from battery....

    see post #3 :nice:
  5. 03ghoststang

    Fine Banjo Bolt 02 Mustang

    i had to get mine through Ford so i would say dealership item
  6. 03ghoststang

    Well I went to the race track *VID*

    :hail2: :hail2: :hail2: that is all
  7. 03ghoststang

    19.5 Volts from battery....

    your voltage regulator took a chit time for a new alternator, had it happen on my 5.0 i was getting 20.x volts replaced it gone
  8. 03ghoststang

    Fuel Pump?

    well on my car i know that i run it a bit hard after i shut it off i get a little pop form one of the mufflers like a back fire but then again i have a O/R pipe :shrug:
  9. 03ghoststang

    Bi-Xenon HID

    interesting i only have the single filament HID (low-beam) i would also like to know if anyone has them
  10. 03ghoststang

    Talked to AMP PERF... what do you think of their recomendation?

    go with a 3200stall T.C........and the 4.10's....if you dont have a trans cooler you should do this also
  11. 03ghoststang

    Ring and pinion pattern

    the pattern should beon the gears if they where on another vehicle.....you may need a shim kit to get the gears in the set pattern they have. but you dont want your backlash too tight or you will have a pattern more towards the inside...keep it between .010-.012 as far as the shims go there...
  12. 03ghoststang

    Best Oil for California winter

    just keep using what you are currently using, i myself use Mobil1 5w-30 full syn.
  13. 03ghoststang

    Car Hesitates under WOT

    for the hestitation check your plugs.....as for the coolant smell just recheck everything and make sure you dont have a minor leak
  14. 03ghoststang

    Rear Brake Job

    i should clear what i said earlier. I'm a mechanic and when i do brake inspections i have come across a few cars that have rotors that are undersized and they have never been turned before
  15. 03ghoststang

    Rear Brake Job

    and ford aint the only manufacturer that has them i've seen them on acuras and a few others
  16. 03ghoststang

    2003 mustang gt exhaust

    i would go with bassani ... i have gone with that catback from day 1 and had about 3 different combos... stock H-pipe and catback nice mellow deep tone a bit louder than stock.... Bassani X-pipe with catback much louder and deeper ......... current set up O/R prochamber and catback gets quiet...
  17. 03ghoststang

    Rear Brake Job

    :stupid: i have had a couple cars that where due for there first brake job and the rotors where undersized. But if you can get yours measured and are over spec go ahead and turn them
  18. 03ghoststang

    Mustang dies at Highway speeds!!

    my car did something similar when it was new ended up being a connector by the battery junction box
  19. 03ghoststang

    Squeal like a pig...lol, its late!

    well it can be the tensioner or the belt.........spray some lubricant on the belt if it goes away then its the belt slipping
  20. 03ghoststang

    HELP: Exhaust

    hard to tell cause i use to havea basani X-pipe and i would scrape once in a while
Top Bottom
Back
Forums
Menu