I’m building a 1966 Shelby GT-350 Convertible, want to know what type of 4 spd was installed? And if it’s a Borg Warner T-10, what was the spline count? And is anyone selling one? Thanks for any input given.
Hey all, I have a 1965 Mustang Convertible that I am restoring and I have a big problem...the data plate is confusing the crap out of me. At the end of the data plate there is a 6 F...which you can see in the photos...what the heck does that mean? Thank you for your help!
Listed is a NEW Exterior Door Handle Kit, Chrome, Made in USA for 1965-1966 & 1969-1970 Mustang. This kit includes both the driver and passenger side handles, gasket pads, buttons, attaching hardware kit and pads shown in the bag (see pictures). *Also fits 1964-1965 2-door Falcon/Comet...
These were originally purchased new in the 90's from a parts department at Ted Britt Ford (a Ford dealer) in Fairfax, VA (last ones from the east coast I was told at the time of purchase). These are not aftermarket parts, they are Ford parts made with Ford tooling and can't be bought...
These were purchased new from a Ford dealer in Fairfax, VA (last ones from the east coast). These are not aftermarket parts, they are Ford parts and can't be bought from Ford anymore. They were stored inside and never used. I no longer have the project I intended to use them on. They are in...
I bought this engine from a friend who totaled their 2014 F150 with 15,000 miles. Truck was rear ended. Was going to use for my 1967 mustang coupe. I am realizing how expensive the swap is going to be so thinking about selling. Motor is almost brand new and has everything except throttle body...
I took this Griffin Radiator off of my old 65 Mustang and will not be reusing it on my new rebuild. Model # 7-565BC-CAX. It was not used very much, but the outside could use a little clean up. Also, it comes with a chrome overflow. $350/obo
I'm new here, and just got my "65" this weekend!!! Lots of work to do and hope you all don't mind stupid questions! I had a 6 cyl "65" back in the 80's and always wanted a nice finished V-8. I'm gonna need a paint job and lots of advice!
These were purchased new from Ford (last ones from the east coast), but they were stored inside and never used. They are in great condition and currently located in Springfield, Virginia. I am currently listing these for local pickup only at this time. Meant for coupes and possibly can be used...
39TH annual fall regional Shelby/Mustang event. Held at the Biltmore Square Mall in Asheville, NC. Ranging from Classic to Modern with Borla at the event showing off there systems and some engines on display with ITB'S " individual throttle body's " . Very good event hosted by great people in a...