diff

  1. G

    1967 mustang 9" Limited slip issue 28 spline

    Any one knows if a limited slip, should always have retaining rings at the old clutch pack assembly, as I opened mine up to check and spot there's none with, so I,m not sure if every type should have these or not also it didn't have any shims within the clutch assembly either not even the two...
  2. Alpine615

    Drivetrain Driver's Side Axle Shaft Not Seating Properly In Diff

    Hey all, my name is Steve and I'm new here. Technically I do not own a Mustang II, but I have an 8" rear end from one that's going into my Pinto. I figured this would be the best place to get help. Thanks in advance... I had the axles out to be drilled for 5 x 4.5" bolt pattern, with new...
  3. D

    Sos!! Need Help With An 83

    Hi all, New to the forum, just picked up my first foxbody. It had a blown diff, so I replaced it no sweat(except losing one of the axle retainers for about an hour) and I go to pull the fill plug and the thing is nearly impossible to get a good angle on without dropping the axle it seems. I have...
Top Bottom
Back
Forums
Menu