Looking for some direction. Two years ago I did a valve job on my 1966 Mustang 200. When I put it back together it ran so much better with a ton more power, no knocking and great acceleration. Ran that summer fine and then part way last summer if I drove it for an hour or so it would start to run rough and would stall. Would not start back up until about 30 minutes later as though nothing happened and would run no problem.
I have read a a lot on vapor lock, but nothing has changed and cant see where the fuel line would be getting hot enough to cause a vapor lock.
Any thoughts.
Getting gas
New Rotor
New Cap
New Plugs
New Wires
Again if it cools off for more than 30 minutes starts right up.
I have read a a lot on vapor lock, but nothing has changed and cant see where the fuel line would be getting hot enough to cause a vapor lock.
Any thoughts.
Getting gas
New Rotor
New Cap
New Plugs
New Wires
Again if it cools off for more than 30 minutes starts right up.