Hey Everyone,
Hope I can get some help here. I recently had my 2006 V6 Mustang's rear bumper replaced and repaired. The stripe that the car had when I bought it was as seen in the following link:
http://www.allfordmustangs.com/forum...q_2006gt_2.jpg
Note the thin lanes of vinyl on the very edge of the stripe job. My plan was to have this same job recreated to the rest of the car at the shop I currently have it at now, however, they have informed me that Ford's stripe kits do not resemble that of the above link. Ford's stripe kits are just two lanes of solid vinyl w/out that tiny piece of cut on the edge.
If the body shop cannot cut the vinyl they received from Ford to recreate this look,I will most likely need to go someplace else.
Does anyone know/recommend a good shop that is capable of this type of job in the Bay Area? Looking to spend tops $250-$350 on the job.
Hope I can get some help here. I recently had my 2006 V6 Mustang's rear bumper replaced and repaired. The stripe that the car had when I bought it was as seen in the following link:
http://www.allfordmustangs.com/forum...q_2006gt_2.jpg
Note the thin lanes of vinyl on the very edge of the stripe job. My plan was to have this same job recreated to the rest of the car at the shop I currently have it at now, however, they have informed me that Ford's stripe kits do not resemble that of the above link. Ford's stripe kits are just two lanes of solid vinyl w/out that tiny piece of cut on the edge.
If the body shop cannot cut the vinyl they received from Ford to recreate this look,I will most likely need to go someplace else.
Does anyone know/recommend a good shop that is capable of this type of job in the Bay Area? Looking to spend tops $250-$350 on the job.