• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Car Won't Start. Dash Lights don't turn on.

  • Thread starter Thread starter STANGNUM
  • Start date Start date Jan 19, 2007
S

STANGNUM

New Member
Nov 1, 2005
10
0
0
Jan 19, 2007
#1
  • Jan 19, 2007
  • #1
Hey guys I got a 93 5.0 GT 5 speed.. Here's my problem I'm having..Car was running fine, battery fully charged connections all tight..Well I turned the car off and came back a little later..The car's dash lights turned on like normal then it clicked like it was gonna start, next thing all lights went dead, no motor cranking or anything..

I put a charger on the car to see if it would start over..Nope nothing happened..Here's something weird..I turned the headlights on, they didnt turn on at first then they flickered on then back off...So I thought maybe battery faulty and not holding a charge..So I get my second battery out of my SHO that runs fine.. Well the dash lights turned on again the first time ignition turned on..Then no lights again in the dash or attempts at cranking.. I doubt 2 batteries are dead..

Last thing I did was check the fuses...Fuses light up when checking with the key in off position..When I turn ignition on and try checking, no fuses light up.. So I'm thinking the ignition switch is faulty maybe? Any ideas? Sorry for the story.. Thanks in advance..

:SNSign:
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jan 19, 2007
#2
  • Jan 19, 2007
  • #2
Here's a checklist:

Since some of the tests will bypass the safety interlocks, make sure that the car is in neutral
and the parking brake is set. Becoming a pancake isn’t part of the repair process…


Check battery, terminal connections, ground, starter relay switch (also known as solenoid) and
starter in that order. Battery cables with the replacement ends that clamp on the cable with 2 bolts
are a know problem source.

A voltmeter is handy if you are familiar with how to use it to find bad connections. Measure the
voltage drop across a connection: more than .5 volts across a connection indicates a problem.

See http://www.fluke.com/application_notes/automotive/circuit.asp?AGID=1&SID=103
for help


1.) Will the car start if it is jumped? Then clean battery terminals and check battery.

2.) Check the battery to engine block ground, and the ground behind the engine to the firewall.

3.) Jump the big terminals on the starter relay next to the battery with a screwdriver - watch out
for the sparks! If the engine cranks, the starter and power wiring is good. The starter relay is also
known as a starter solenoid.

4.) Then pull the small push on connector (red wire) off the starter relay (Looks like it is stuck on a
screw). Then jump between the screw and the terminal that is connected to the battery. If it starts,
the relay is good and your problem is in the rest of the circuit.

5.) Remember to check the ignition switch, neutral safety switch on auto trans and the clutch
safety switch on manual trans cars. If they are good, then you have wiring problems.

Typical start circuit...

Diagram courtesy of Tmoss and Stang&2birds.


See http://www.autozone.com/images/cds/gif/large/0900823d80195963.gif for 88-90
year cars .OR see http://www.autozone.com/images/cds/gif/large/0900823d80195964.gif
for 91-93 year cars. See http://www.autozone.com/servlet/UiB..._us/0900823d/80/1d/db/3c/0900823d801ddb3c.jsp for 94-95
model cars.

6.) The starter may be hung, loosen up the bolts that hold it on, and give it a good whack with a
big hammer. Tighten up the bolts and try again.

7.) If that doesn't work, use a jumper cable from the positive lead on the battery direct to the
starter post where the big wire from the relay connects. If it cranks then, it is the power wire from
the relay gone bad. This will be hard to do, since there isn't much room to do it.

8.) Pull the starter and take it to Autozone or Pep Boys and have them test it. Starter fails test,
then replace it. If you got this far, the starter is probably bad.
 
S

STANGNUM

New Member
Nov 1, 2005
10
0
0
Feb 4, 2007
#3
  • Feb 4, 2007
  • #3
Well it ended up being the positive cable from battery to solenoid. I changed it and the negative cable at the same time.. It fired right up no problems.
 
You must log in or register to reply here.

Similar threads

E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
128
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
S
Electrical No dash lights
  • slojoexxx
  • Dec 11, 2025
  • 1994 - 1995 Specific Tech
Replies
0
Views
145
1994 - 1995 Specific Tech Dec 11, 2025
slojoexxx
S
J
1990 fox starts on starting fluid only
  • Jfox
  • May 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
9
Views
193
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 15, 2026
AeroCoupe
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
235
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
M
Electrical 1989 mustang dash lights
  • Mustang_65-87
  • May 9, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
1K
Fox 5.0 Mustang Tech May 24, 2025
Mustang_65-87
M
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?