(1) Let it sit flat on the ground overnight
(2) Jack-Up the front of your car.. may not have to, mine is lowered
(3) put into place where you want it, and tape it on for security (might need a helper)
(4) Drill holes
(5) Place Clips
(6) Enjoy
I agree with the above, but if you got it from CDC they dont fold it so step 1 would be unnessecary.
I didn't jack the front of the car up cause I only had one stand, and I was scared to put it on ramps in case the chin wouldnt clear on the way off.
I used the light brown/tan scotch tape to hold it up. You can line the end of it up with the front of your wheel wells for the Mach look, or line the front of the chin up with the front of the bumper for a "different"(a lot of people are doing this now so its no longer different) look.
I used some lock tite on the plastic screws as well just in case, but drill; insert the tabs; then tighten the screws, you're done, minus the lining up it shouldnt take more than 5 min.
(1) Let it sit flat on the ground overnight
(2) Jack-Up the front of your car.. may not have to, mine is lowered
(3) put into place where you want it, and tape it on for security (might need a helper)
(4) Drill holes
(5) Place Clips
(6) Enjoy