• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Cruise Control

  • Thread starter Thread starter AP1995V6
  • Start date Start date Dec 17, 2003

AP1995V6

Member
Jul 13, 2003
547
1
16
Oxford, MS
Dec 17, 2003
#1
  • Dec 17, 2003
  • #1
It doesn't work. Anyone have any suggestions to what to look at before I take it to the dealer?

*note: hasn't worked since i've owned the car.
 

marvinmycat

Founding Member
Feb 13, 2002
1,179
0
0
Buffalo, NY
Dec 18, 2003
#2
  • Dec 18, 2003
  • #2
Look for the guy that sold it too you!

Seriously, pop the covers off and see what's behind them. Maybe as simple as a non-functional On/Off switch, or a loose wire.
 
E

ExplodingTurtle

New Member
Dec 2, 2003
39
0
0
Um... my computer, duh.
Dec 19, 2003
#3
  • Dec 19, 2003
  • #3
AP1995V6 said:
It doesn't work. Anyone have any suggestions to what to look at before I take it to the dealer?

*note: hasn't worked since i've owned the car.
Click to expand...

My friends stang had cruise control and it broke too... is this common or something?
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
Dec 19, 2003
#4
  • Dec 19, 2003
  • #4
check the fuse first off!
 

AP1995V6

Member
Jul 13, 2003
547
1
16
Oxford, MS
Dec 19, 2003
#5
  • Dec 19, 2003
  • #5
All the fuses are good. Everything is hooked up good. However, under my dash there was a grey connector that's just dangling there and I couldn't find anything for it to connect to so I have no idea what it is for.
 

98CobraClone

New Member
Feb 28, 2003
592
0
0
Ripley, Ohio
Dec 20, 2003
#6
  • Dec 20, 2003
  • #6
don't need no stinking cruise......put a brick on the pedal and go
 
S

STM1965

Member
Mar 24, 2003
185
0
16
Ontario
Dec 21, 2003
#7
  • Dec 21, 2003
  • #7
Its cheaper to pay an auto electric shop to figure out whats wrong then if possible fix it your self. I just did one on my stang last spring, the sevro unit was NFG and it's located under the left front fender tucked up against the fire wall. It's a pain in the ass to swap out. I also just replaced the same unit on a 93 Areostar mini van much easier to get at. If its the sevro unit it'll run you maybe $50 to $60 bucks at a wreckers, new $300 to $400 from Ford!
 

AP1995V6

Member
Jul 13, 2003
547
1
16
Oxford, MS
Dec 22, 2003
#8
  • Dec 22, 2003
  • #8
Can I just take out all the cruise wiring and stuff from the dash back? If it's not going to work, and I don't care too much if it does or doesn't, I might as well get rid of some of the clutter.
 
C

cgrant

New Member
Dec 6, 2003
132
0
0
Dec 22, 2003
#9
  • Dec 22, 2003
  • #9
AP1995V6 said:
Can I just take out all the cruise wiring and stuff from the dash back? If it's not going to work, and I don't care too much if it does or doesn't, I might as well get rid of some of the clutter.
Click to expand...

Don't just get rid of them! Atleast rewire them to be a volume up/down and cd/radio/dvd controls, much more useful then cruise control anyway I think
 

AP1995V6

Member
Jul 13, 2003
547
1
16
Oxford, MS
Dec 22, 2003
#10
  • Dec 22, 2003
  • #10
I didn't think about that. I was mostly referring to the crap attached to the throttle body.
 
J

Jaice

New Member
Sep 14, 2003
21
0
0
Dec 22, 2003
#11
  • Dec 22, 2003
  • #11
He may not use it much, but If you paid for it, you still want to to work.

My Stepdad had a Camry, bout it in 88 brand new, used the cruise control once in 97 and the thing never worked again.
 

marvinmycat

Founding Member
Feb 13, 2002
1,179
0
0
Buffalo, NY
Dec 23, 2003
#12
  • Dec 23, 2003
  • #12
Cruise Control Inoperative:

Blown fuse
Short or open in the cruise conrol circuit
Faulty brake or clutch switch
Leaking vacuum circuit
Faulty cruise control switch
Faulty stepper motor
Faulty transducer
Faulty speed sensor
Fulty cruise control module
 

75player

New Member
Dec 22, 2003
58
0
0
North Carolina
Dec 23, 2003
#13
  • Dec 23, 2003
  • #13
My 98s cruise has been out of commision since 99. I've checked the fuses and discovered that ford mislabeled the fuses in the car, owners manual, and even the shop service manuals (At least on the 98s). The fuse for the cruise is good, but cruise control don't work.The fuse that is supposed to be for the powered drivers seat is blown, and blows immediately every time I replace it, yet the seat still works. It's been a couple years since I looked at it, but I beleive the cigarette lighter is supposed to on the same fuse as the seat and the lighter doesn't work. Very strange.
 

marvinmycat

Founding Member
Feb 13, 2002
1,179
0
0
Buffalo, NY
Dec 23, 2003
#14
  • Dec 23, 2003
  • #14
That sounds like a short to me.
 
G

guitars1116

New Member
Oct 4, 2003
8
0
0
Illinois
Dec 23, 2003
#15
  • Dec 23, 2003
  • #15
:My 98s cruise has been out of commision since 99. I've checked the fuses and discovered that ford mislabeled the fuses in the car, owners manual, and even the shop service manuals (At least on the 98s). The fuse for the cruise is good, but cruise control don't work.The fuse that is supposed to be for the powered drivers seat is blown, and blows immediately every time I replace it, yet the seat still works. It's been a couple years since I looked at it, but I beleive the cigarette lighter is supposed to on the same fuse as the seat and the lighter doesn't work. Very strange.

I have the same problem with my 98. The drivers seat controls work and so does the curise control but neither of the lighters work and I've looked in the manuel to check the fuse but it isn't listed in there. If you guys know which fuse it is let me know thanks.
Click to expand...
 
You must log in or register to reply here.

Similar threads

P
New here
  • PortCity
  • Jun 9, 2026
  • The Welcome Wagon
Replies
2
Views
98
The Welcome Wagon Jun 9, 2026
AeroCoupe
J
SN95 Hello new to this app
  • James S
  • Jun 10, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
123
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 11, 2026
Habu135
3
B&m hammer shifter c4 question
  • 387lx
  • Mar 18, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
4
Views
298
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 19, 2026
387lx
3
S
Best place to source power steering parts for a '67? (control valve, ram, hoses)
  • SophiaTatum
  • Jun 15, 2026
  • Classic Mustang Specific Tech
Replies
2
Views
85
Classic Mustang Specific Tech Jun 18, 2026
SophiaTatum
S
F
Fox 1988 GT Lumbar controls not working
  • Fcortes795
  • Mar 6, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
130
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 7, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?