Does Anyone Have A Picture Of The Magnaflow 59956 Cats Welded In On Their Off Road H-pipe?

Mstng93SSP

You have a nice rear end there Dave.
15 Year Member
Nov 29, 1999
1,973
2,297
174
Mililani, Hawaii
Does anyone have a picture of the Magnaflow 59956 cats welded in on their off road h-pipe? I just ordered a pair and want to see where on the h-pipe people have welded them in before they get here. Measurements might be helpful too but pictures would be fine.

Thanks

Chris
 
  • Sponsors(?)


MFE92

5 Year Member
Aug 25, 2010
1,094
373
114
Phoenix
This off-road pipe was custom built 18 years ago so its shape is probably different than anything mass-produced, but those are 59956's installed 4 years ago.

H-pipemagnaflowcats.jpg
 

Mstng93SSP

You have a nice rear end there Dave.
15 Year Member
Nov 29, 1999
1,973
2,297
174
Mililani, Hawaii
One more question. I have a 2 1/2 inch off road pipe. THat looks to be what you have there too. The inside diameter of the cats is supposed to be 2 1/2 inches, so did they fit over the pipe, or butt up against the pipe when you welded them.

Thanks

Chris
 

MFE92

5 Year Member
Aug 25, 2010
1,094
373
114
Phoenix
I'm not sure, I didn't do the welding and I didn't watch while they did. They look to be slip-fit, but I don't know for sure.
 

GT80

New Member
Jun 19, 2014
19
0
1
43
Greenville, SC
I realize this is a super old thread, but I was searching for the same answer and since it wasn't really answered definitively I thought I'd add more info for the next person that's searching and stumbles across it. I went ahead and ordered the Magnaflow 59956's and measured them with calipers. The ID is 2.531" (2-17/32") so these should slip over my 2.5" midpipes. In this case I may just use TorcTite clamps instead of welding.
 
Thread starter Similar threads Forum Replies Date
silverlx50 Engine Does anyone have a picture of the O2 sensor harness orange ground wire? Fox 5.0 Mustang Tech 5
P Does anyone have a picture of a 2011 Black GT/CS? 2005 - 2014 S-197 Mustang -General/Talk- 0
Seraphitia102 Does anyone have pictures of Mustangs with 4 and/or 6 piston brake kits? 1996 - 2004 SN95 Mustang -General/Talk- 3
Busted07 Does anyone have pictures of the EIBACH DRAG LAUNCH KIT on thier car? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 4
M Does anyone have a picture of a Fox with these wheels on it? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 9
R Does anyone have pictures of a stang w/black fr500 wheels on it 1996 - 2004 SN95 Mustang -General/Talk- 1
monk302 EFI Pedal Pictures: Does anyone have any Classic Mustang Specific Tech 6
M Does anyone have pictures of their catback exhaust under their car? Fox 5.0 Mustang Tech 1
M Brakes Does anyone know specific casting numbers on 1989 GT O.E. Calipers? Fox 5.0 Mustang Tech 11
J Does anyone know where this wire goes? Other Auto Tech 28
kiddiccarus Does anyone customize the interior of the 94-95? I am running into brick walls 1996 - 2004 SN95 Mustang -General/Talk- 0
ndfox92 Fox does anyone have a victor efi intake for a 351w they want to part with? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 0
M Does anyone know what the hole to the left of the oil pressure sender is for?? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 6
Blucifer99 Does anyone kno the deadtimes and voltage offset for these injectors Digital Self-tuning Forum 0
billison Does anyone else have one of these. 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 15
Hudson N Anyone know what this does? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 7
R Does anyone know how to decode a 1970 Owner's card 1965 - 1973 Classic Mustangs -General/Talk- 5
A Paint and Body Help! Does anyone know what wheels these are? 1996 - 2004 SN95 Mustang -General/Talk- 1
67_Ellie My engine is too big for the a/c does anyone know a solution? 1965 - 1973 Classic Mustangs -General/Talk- 3
B Does anyone out there know what this button does? 2015+ (S550) Mustang -General/Talk 1
T Does Anyone Know??? 2005 - 2014 S-197 Mustang -General/Talk- 2
killer5.0 Does Anyone Know Why A 79-82 Wiper Cowl Cover Wont Fit On A 93? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 12
KevinV Does Anyone Make Black Overlays For The A/c Panel? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 7
T Paint and Body Does Anyone Know What Brand This Hood Is? 2005 - 2014 S-197 Mustang -General/Talk- 5
V Does Anyone Have Information On This Car? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 8
92Apocalypso Does Anyone In The De/md/pa/nj Area Have A Lower Control Arm Bolt??? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 21
92Apocalypso Does Anyone Else Always Have Door Issues? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 13
65-Fstbk Paint and Body Does Anyone Recognize This Fastback? 1965 - 1973 Classic Mustangs -General/Talk- 2
Boosted92LX Mustang Memes... Does This Bother Anyone Else? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 52
Amber Midkiff My Front And Rear Defroster Aren't Working. Does Anyone Know What Could Be The Cause Of This? SN95 4.6L Mustang Tech 3
F Does Anyone Make A Saleen Wing Without The 3rd Brake Light? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 4
RacerJames Does Anyone Else Do This? 1965 - 1973 Classic Mustangs -General/Talk- 12
keithnra Fox Does Anyone Know The Paint Code For The Oem Upper Intake On A 90 Gt 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 5
S SN95 Does Anyone Use Stage 8 Locking Header Bolts? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 12
Ant85 Does Anyone Not Drive Their Mustang During Winter? Fox 5.0 Mustang Tech 5
hoopty5.0 Does Anyone Else Find This Odd? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 26
G Does Anyone Know Anything About Msd 6al Digital Ignitio Fox 5.0 Mustang Tech 0
805mustang Having Sensor Value Issues On Multiple Temp Sensors! Does Anyone Have A Wiring Diagram????? 2005 - 2009 Specific Tech 0
robert912005 Does Anyone Know What This Is? Classic Mustang Specific Tech 6
frankie88 Expired Does Anyone Need A New Radiator Support? Engine and Power Adder Parts 2
warlock3055 HELP! does anyone have a copy of a kenne bell instructions? 1996 - 2004 SN95 Mustang -General/Talk- 1
99 FLA PONY GT Does Anyone Know? SN95 4.6L Mustang Tech 1
A Does Anyone May A Replacement Auto Shifter Slider? SN95 4.6L Mustang Tech 4
9 Does Anyone Gave A Wiring Diagram For 87-89 And 90-93 Cruise? Fox 5.0 Mustang Tech 4
J Does Anyone Know Why Exhaust Prices Have Shot Up? 1996 - 2004 SN95 Mustang -General/Talk- 9
mob Does Anyone Make A Bolt On And Go Coilover Kit? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 56
Tubes Does Anyone Have Experience With Anderson's Pms Iv? Fox 5.0 Mustang Tech 5
geneo4116 DOES ANYONE KNOW OF ANY MUSTANG PERFORMANCE SHOPS AROUND MADISON WISCONSIN 2010 - 2014 Specific Tech 2
metalmechanical Does anyone make a replacement side scoop gasket? SN95 4.6L Mustang Tech 5
Similar threads