Edel head work?

BYRDPE · May 18, 2004

Hello folks,
I have a used set of the 6037s that I purchased over a year ago and I want to get them looked at before installing.
I think they have the stock springs but I'm not sure.I would like to have a 3 angle valve job and hardened spring cups installed and maybe a little bowl work if recommended.
I don't know of anyone local but if someone does please provide a contact name.
If any of the head builders on this site can assist I would appreciate it.
Thanks for the replies.

Ranchero5.0 · May 18, 2004

Sure hope you took a valve out before buying them. I looked at a few sets for around $500 and most were junk once the valves were out. For port work on my dad's set, I smoothed the rough machine edges where the valve seats mount into the aluminum and unshrouded the intake valve a little. The ports were pretty decent, just a quicky port match, nothing too drastic to kill low end flow on his AOD car. With a E cam and GT 40 intake it runs well, but not race car'ish.

Jamie

BYRDPE · May 19, 2004

Ranchero5.0 said:
Sure hope you took a valve out before buying them. I looked at a few sets for around $500 and most were junk once the valves were out. For port work on my dad's set, I smoothed the rough machine edges where the valve seats mount into the aluminum and unshrouded the intake valve a little. The ports were pretty decent, just a quicky port match, nothing too drastic to kill low end flow on his AOD car. With a E cam and GT 40 intake it runs well, but not race car'ish.

Jamie

Nope...I never checked them.
They do LOOK nice tho.
Thanks for the reply.
NE1??

BYRDPE · May 20, 2004

TTT.....

BYRDPE · May 20, 2004

Edel head work?

BYRDPE

Ranchero5.0

The Voice of Reason

BYRDPE

BYRDPE

BYRDPE

Similar threads

Edel head work?

BYRDPE

Ranchero5.0

The Voice of Reason

BYRDPE

BYRDPE

BYRDPE

Similar threads

Privacy & Transparency

Privacy & Transparency