after 3 days or so hard wrenching, and sweat and pain, its in!
It sound...well, different. Its much much quieter at idle then was with my previous set up(ProChamber+Roush Side pipe, which is Magnaflow). But is much more rumblier tho. and once i'm moving, it gets louder then that of old set up. I haven't went past 3000RPM yet, as I'm not 100% sure on all bolts that i tighten, but i can already feel power coming on at around 2500RPM. way it sound at 3000RPM on partial throttle, i can assume it'll scream at 5000RPM...
so I'm very happy. But now my aligment is !@#ked up hard core. it still go straight, but my driver side has no Negative camber left. Infact, i think its more like +1.5 camber....
Oh and my H pipe is hanging lower then my prochamber. and its scrapin everything. I have to raise that little.
But otherwise, if any of you wondering about header, stop wondering and go get them!!!!
I'll take some video tomorrow and post them
It sound...well, different. Its much much quieter at idle then was with my previous set up(ProChamber+Roush Side pipe, which is Magnaflow). But is much more rumblier tho. and once i'm moving, it gets louder then that of old set up. I haven't went past 3000RPM yet, as I'm not 100% sure on all bolts that i tighten, but i can already feel power coming on at around 2500RPM. way it sound at 3000RPM on partial throttle, i can assume it'll scream at 5000RPM...

so I'm very happy. But now my aligment is !@#ked up hard core. it still go straight, but my driver side has no Negative camber left. Infact, i think its more like +1.5 camber....
Oh and my H pipe is hanging lower then my prochamber. and its scrapin everything. I have to raise that little.
But otherwise, if any of you wondering about header, stop wondering and go get them!!!!
I'll take some video tomorrow and post them
