• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Help with starting problems!!!!

  • Thread starter Thread starter 1SLO306
  • Start date Start date Dec 28, 2005
1

1SLO306

My 97 GTP owns you ALL!
Mar 31, 2005
904
1
17
Muhlenberg, ky
Dec 28, 2005
#1
  • Dec 28, 2005
  • #1
I know what the problem is but i cant figure out what keeps causing it. I sitched the intake on my car and i kept blowing the ignition module. What is some things that cause this to happen???

Thanks,
Blake
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Dec 28, 2005
#2
  • Dec 28, 2005
  • #2
Possible bad ground.

1.) The main power ground is from engine block to battery: it is the power ground for the starter & alternator.

2.) The secondary power ground is between the back of the intake manifold and the driver's side firewall. It is often missing or loose. It supplies ground for the alternator, A/C compressor clutch and other electrical accessories such as the gauges. Any car that has a 3G alternator needs a 4 gauge ground wire running from the block to the chassis ground where the battery pigtail ground connects.

3.) The computer has its own dedicated power ground that comes off the ground pigtail on the battery ground wire. Due to it's proximity to the battery, it may become corroded by acid fumes from the battery. It is a black cylinder about 2 1/2" long by 1" diameter with a black/lt green wire. The wire goes into the harness at the starter solenoid.

4.) All the sensors have a common separate ground. This includes the TPS, ACT, EGE, BAP, & VSS

5.) The O2 sensor heaters have their own ground (HEGO ground) coming from the computer. This is different and separate from the O2 sensor ground. It is in the fuel injector wiring harness and comes out under the throttle body. It gets connected to a manifold or head bolt.

6.) The TFI module has 2 grounds: one for the foil shield around the wires and another for the module itself. The TFI module ground is a signal ground that terminates inside the computer.


7.) The computer takes the shield ground for the TFI module and runs it from pin 20 to the chassis near the computer.

8.) The computer's main power ground (the one that comes from the battery ground wire) uses pins 40 & 60 for all the things it controls internally.

See http://www.fluke.com/application_notes/automotive/circuit.asp?AGID=1&SID=103#volt for help troubleshooting voltage drops across grounds
 

jadedinpa

Founding Member
Aug 2, 2002
1,094
0
0
lancaster, pa
Dec 28, 2005
#3
  • Dec 28, 2005
  • #3
also, check for pinched wires.
 
You must log in or register to reply here.

Similar threads

Strange timing issue
  • 92 Bimini Blue
  • Sep 26, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
22
Views
725
Fox 5.0 Mustang Tech Oct 20, 2026
rednotch
B
Resolved Crank no start after engine swap
  • biggrim
  • Sep 12, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
100
1996 - 2004 SN95 Mustang -General/Talk- Sep 12, 2026
biggrim
B
P
Fuel New Eldebrock 1406 problems 1985 GT 5.0
  • Paddyman
  • Oct 22, 2026
  • Fox 5.0 Mustang Tech
Replies
4
Views
176
Fox 5.0 Mustang Tech Nov 2, 2026
manicmechanic007
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
520
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
M
Idle control problems
  • miser143
  • Aug 28, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
211
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 29, 2026
DadLife0724
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?