Hiding wires.. passenger side

[ALMOST STOCK]

Did you have any issues at all on the passenger side, as to lengthening wires/vac lines at all?

Re- routing the wires, was easy / the vacuume were even easier.

 

[Mavrick]

Nope nothing on the passenger side needs to be lenghthened. For that matter don't run the MAF wire connector in the hole behind the Strut Tower either, run it under the piping from the TB to outside air. If that makes any since ?
I'm still fighting my pi$$ poor satellite connection, just hang in there it's got to get better I hope

Ok so im going to setup everything like in your pics, except run the mass air wires under the air inlet tube? Easy enough.

Will be nice to have those stupid relays out of the way.

How did you mount everything inside the fender? You couldn't have used screws.. that would ruin the finish of the fenderwells while looking under the hood?

 

[ALMOST STOCK]

Ok so im going to setup everything like in your pics, except run the mass air wires under the air inlet tube? Easy enough.

Will be nice to have those stupid relays out of the way.

How did you mount everything inside the fender? You couldn't have used screws.. that would ruin the finish of the fenderwells while looking under the hood?

This is my third time trying to post, so bear with me .
So what you're asking is now I held things into place that's easy.
Tie straps or some ppl call them Tie raps .