• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

I need help!!! New TB!! Bad Idle!!!!!!

  • Thread starter Thread starter fourmustangs
  • Start date Start date Feb 26, 2006
F

fourmustangs

New Member
Mar 30, 2005
92
0
0
Houston
Feb 26, 2006
#1
  • Feb 26, 2006
  • #1
I just put a throttle body on my 87 5.0 with AOD.
It was running great then next thing I know My rpms are staying 3000-4000 rpm.
It now is at 1600 rpm at idle and because of the idle the shifting is just a little off.

Adjusting the idle screw is n/a it ran good just before.
the tps is good has the right voltage.

I have checked the codes and not a single code....all ok

let me know what you think cause I dont know.

ps. I've checked almost all vacuum ports no problems in engine bay.
 

troyGT03

New Member
Feb 22, 2004
278
0
0
too close to memphis,tn
Feb 26, 2006
#2
  • Feb 26, 2006
  • #2
unplug the iac, then adjust the idle screw and tps(as close but not 1volt DC as possible) to get a idle @ 900(auto). it will run a bit rough but will idle if no vac leaks. then plug the the iac in. jricker and hissin50 will give you the better explanation. i gave you the cliffs notes.
 
F

fourmustangs

New Member
Mar 30, 2005
92
0
0
Houston
Feb 26, 2006
#3
  • Feb 26, 2006
  • #3
Thats how I set it and rechecked the voltage once the problem hit
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Feb 26, 2006
#4
  • Feb 26, 2006
  • #4
Are you really sure the throttle blade is not sticking (this is an issue with some aftermarket TB's)? The throttle linkage is not able to get stuck or hung up?

If one desired, you could run wiring from the TPS signal-return to your DMM and put the meter in your car - that way you can monitor TPS readings in real time (best to have an assitant, etc do that, so it is not a distraction).

Here is an article on resetting the idle (you have gone over it I am sure, but redundancy when trying to find a solution doesnt hurt).

Good luck.
 
F

fourmustangs

New Member
Mar 30, 2005
92
0
0
Houston
Feb 27, 2006
#5
  • Feb 27, 2006
  • #5
It wasnt stuck it has free play.

When it was running right itwas about 950 rpms
I got on it a few times and was going to the strip and on the way there and when I was there it acts like the throttle is stuck open when its not.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Feb 27, 2006
#6
  • Feb 27, 2006
  • #6
An idle that goes high and stays high until you shut off the engine is a sign of a bad TPS.


Wire colors & functions:
Orange/white = 5 volt VREF from the computer
Dark Green/lt green = TPS output to computer
Black/white = Signal ground from computer

Check the orange/white wire for 5 volts.

Note that all resistance tests must be done with power off. Measuring resistance with a circuit powered on will give false readings and possibly damage the meter.
Check the resistance betwee the black/white wire on the TPS and the negative battery post. You should see less than 1.5 ohms.
 
F

fourmustangs

New Member
Mar 30, 2005
92
0
0
Houston
Feb 27, 2006
#7
  • Feb 27, 2006
  • #7
Changed TPS and made couple adjustments and it idles at 1000.
any lower it starts to surge.

seems to be running good now
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Feb 27, 2006
#8
  • Feb 27, 2006
  • #8
fourmustangs said:
Changed TPS and made couple adjustments and it idles at 1000.
any lower it starts to surge.

seems to be running good now
Click to expand...
See the sticky "Help me create the Surging Idle Checklist" at the top of the forum for help with your idle problems. The first post in the sticky has almost all the details you need.
 
You must log in or register to reply here.

Similar threads

L
Engine 85 GT Excessive Idle
  • lutzkecj
  • Sep 18, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
379
Fox 5.0 Mustang Tech Sep 21, 2026
86HO5.0
8
K
Resolved Need some assistance. Holley Terminator X alongside H/C/I. Very rough/inconsistent idle
  • karhoot
  • Jun 6, 2026
  • Fox 5.0 Mustang Tech
Replies
0
Views
238
Fox 5.0 Mustang Tech Jun 6, 2026
karhoot
K
B
Help! Fox with idle issues
  • bbarton
  • Sep 11, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
310
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 12, 2026
AeroCoupe
Engine Random Misfire at idle.
  • Gulftown980x
  • Jul 29, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
624
SN95 4.6L Mustang Tech Jul 31, 2026
squeak93
Engine Stock TB - smoke test - leaking bad
  • R82148V
  • May 18, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
28
Views
2K
Fox 5.0 Mustang Tech Jun 5, 2025
R82148V
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?