• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Indicator Lights Not Working On Initial Startup

  • Thread starter Thread starter koala33
  • Start date Start date Feb 16, 2014
  • 1
  • 2
Next
1 of 2 Next Last

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#1
  • Feb 16, 2014
  • #1
posted a similar thread about the airbag light staying on but I want to elaborate and check into another issue. I pulled the cluster (91 GT) and replaced the "illumination" bulbs with LED bulbs. All of the other bulbs are OEM and in working condition. In the process of all of this my battery died - I recharged and it is good to go. Just mentioning this in case it may have something to do with this problem. When I turn the key over the check engine light comes on for a few seconds like it is supposed to. TThe airbag light was staying on - I ended up pulling the bulb all together. What I am really trying to figure out is, why am I not getting the low coolant, low oil etc light when I initially turn the car on? I know they are supposed to all turn on for a few seconds and then turn off. II disconnected battery for 10 minutes to try to reset ECU (mainly for the airbag light) but still only getting check engine light initially. All of my other lights work great and the panel looks great with the 5 - LED bulbs in there. Any ideas?
 

89oem

Mustang Master
Dec 18, 2013
1,456
542
144
Feb 16, 2014
#2
  • Feb 16, 2014
  • #2
ive read the led lights only work one direction so try turning/plugging one or two to the opposite polarity in the plug?
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#3
  • Feb 16, 2014
  • #3
89oem said:
ive read the led lights only work one direction so try turning/plugging one or two to the opposite polarity in the plug?
Click to expand...
they are not LED, they are OEM bulbs.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#4
  • Feb 16, 2014
  • #4
I am pretty sure they OEM bulbs go in either way. and I tested before I put them in so they were working.. wondering if I messed some contacts up in the harness from plugging/unplugging 10 times to test the other bulbs. I doubt it though. something is up just not sure what. I certainly don't want to take the dash apart again.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#5
  • Feb 16, 2014
  • #5
In other words there are 16 total bulbs in the cluster. 6 are illumination bulbs and the rest are battery, turn signals, high beams, warning lights etc. All of then remained unchanged except the illumination bulbs which just light the dash.
 

Grabbin' Asphalt

10 Year Member
Jun 10, 2013
2,029
310
124
Atlanta, Ga
Feb 16, 2014
#6
  • Feb 16, 2014
  • #6
Pics of your lights in your dash??
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#7
  • Feb 16, 2014
  • #7
Grabbin' Asphalt said:
Pics of your lights in your dash??
Click to expand...
I will send when I get home. everything is perfect aside when you first startup and get those warning lights for a few seconds to show they are working.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#8
  • Feb 16, 2014
  • #8
 
Reactions: Grabbin' Asphalt

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#9
  • Feb 16, 2014
  • #9
That pic is from last night. no Idea why temp was so high, I didn't realize until someone pointed it out. It wasn't hot so I hope I didn't screw the gauge up. going to check it all put again tonight.
 

Grabbin' Asphalt

10 Year Member
Jun 10, 2013
2,029
310
124
Atlanta, Ga
Feb 16, 2014
#10
  • Feb 16, 2014
  • #10
koala33 said:
That pic is from last night. no Idea why temp was so high, I didn't realize until someone pointed it out. It wasn't hot so I hope I didn't screw the gauge up. going to check it all put again tonight.
Click to expand...

When your car is off and you turn your lights on after its warm it will rise automatically, mine does it too. No worries...
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#11
  • Feb 16, 2014
  • #11
Grabbin' Asphalt said:
When your car is off and you turn your lights on after its warm it will rise automatically, mine does it too. No worries...
Click to expand...
ahhhh ok
 

Grabbin' Asphalt

10 Year Member
Jun 10, 2013
2,029
310
124
Atlanta, Ga
Feb 16, 2014
#12
  • Feb 16, 2014
  • #12
koala33 said:
Click to expand...

So looking at your lights compared to mine, I see your white pointers instead of orange ones and a yellow 5000rpm bar instead of orange, looks good. All your green is brighter too, you're making me think of doing it. Whats involved, just swaping bulbs??
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#13
  • Feb 16, 2014
  • #13
Grabbin' Asphalt said:
So looking at your lights compared to mine, I see your white pointers instead of orange ones and a yellow 5000rpm bar instead of orange, looks good. All your green is brighter too, you're making me think of doing it. Whats involved, just swaping bulbs??
Click to expand...
yes just swap out to LED bulbs. just change the illumination bulbs indicated on back of cluster. it is a pain to take It all apart. not too bad. I need to figure out why my warning bulbs aren't working right though.
 

Grabbin' Asphalt

10 Year Member
Jun 10, 2013
2,029
310
124
Atlanta, Ga
Feb 16, 2014
#14
  • Feb 16, 2014
  • #14
My fuel pressure gauge lights up green with an orange pointer and its all similar to my dash. Not sure if I want to break up the theme but I'll look into it.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#15
  • Feb 16, 2014
  • #15
If you use single LED rather than 5 it will look closer to original which is what I should have done. I have a bunch of single just don't want to open dash back up.
Grabbin' Asphalt said:
My fuel pressure gauge lights up green with an orange pointer and its all similar to my dash. Not sure if I want to break up the theme but I'll look into it.
Click to expand...
 

Grabbin' Asphalt

10 Year Member
Jun 10, 2013
2,029
310
124
Atlanta, Ga
Feb 16, 2014
#16
  • Feb 16, 2014
  • #16
koala33 said:
If you use single LED rather than 5 it will look closer to original which is what I should have done. I have a bunch of single just don't want to open dash back up.
Click to expand...

You used 5 green ones spread out??
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#17
  • Feb 16, 2014
  • #17
Looks like it is working as it should... View: https://www.youtube.com/watch?v=elwtpK8og28&feature=youtube_gdata_player
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#18
  • Feb 16, 2014
  • #18
Grabbin' Asphalt said:
You used 5 green ones spread out??
Click to expand...
no. order either the single LEDs or the 5-LEDs and replace I'm the "illumination" slots. There are black fixtures that hold the bulbs. pop put OEM bulb and replace with LED. There are some step by step instructions on the Internet - I don't have the link handy. you have to take your cluster out which takes some time, maybe longer for me since I've never done it.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#19
  • Feb 16, 2014
  • #19
koala33 said:
no. order either the single LEDs or the 5-LEDs and replace I'm the "illumination" slots. There are black fixtures that hold the bulbs. pop put OEM bulb and replace with LED. There are some step by step instructions on the Internet - I don't have the link handy. you have to take your cluster out which takes some time, maybe longer for me since I've never done it.
Click to expand...
white LEDs not green. If you go with single instead of the 5-LED it will not be as bright and might retain some of those colors you said we're lacking because of the brightness.
 

koala33

Member
Apr 28, 2012
181
5
19
Fort Belvoir, VA
Feb 16, 2014
#20
  • Feb 16, 2014
  • #20
Close thread, I think I am good to go.
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

1
Electrical 1985 mustang gt Led conversion trouble
  • 1985fox
  • Jan 5, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
533
Fox 5.0 Mustang Tech Jan 15, 2026
1985fox
1
S
Electrical Foxbody Dash & Hazard lights not working
  • sjmcr
  • Jun 30, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
606
Fox 5.0 Mustang Tech Jul 27, 2025
Mindseye007
C
Lighting issue
  • ChrisCruz1972
  • Jul 2, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
131
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 3, 2025
AeroCoupe
M
Need help!
  • Masonevans726
  • Dec 17, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
213
1996 - 2004 SN95 Mustang -General/Talk- Dec 17, 2025
Masonevans726
M
Z
Right side of cluster not illuminating 91 LX Hatch
  • Zeke1995
  • Jul 21, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
128
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 21, 2025
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?