SO i just finished installing my qa1 k member reused the stock a arms, now the problem is the toe on the alignment it out bad. one wheel will be pointing straight one will be pointing slightly left or right. do i just need a good alignment or did i mess something up on the rack/pinion???
when you installed the k-member, did you mark down all the measurements with plumbbobs? i know its not from the same company, but the instructions that MM gives for their K-Member are excellent.
if i were you i would get it flat-bed towed to an alignment shop before you drive it.
Tube K is bolt on - per say.
But u have to take all sorts of measurement(like that on MM instruction), or else your aligment will be all out of whack....