Mice: Feces, Nest, Wire Damage

Well I have confirmed that my car was stored in a barn by the previous owner. I always wondered why one of my injector wires had a repair. Last night I was cleaning and taking the engine apart and discovered feces and a nest

I used the pictured extension on my shop vac to remove the feces and nest material. I had to take off the intake, TB, blower elbow, and the rail that all the crap is mounted on the driver's side.
View attachment 419701

If you look into the deep crack in these pics you can see yellow/brown discoloration. This is the remnants after I cleaned all the mouse feces out of the crack. I shined up the fuel rails while I was in here also
View attachment 419703
View attachment 419705
View attachment 419707
View attachment 419709

Below the elbow there was nest material, quite a bit of it actually. Very time consuming to get it all out. Unfortunately you cannot see it in the pic:
View attachment 419711

Cleaned TB while it was off, these are the nasty before pics:
View attachment 419713
View attachment 419715

I took the stamped steel "rail" off that was holding all the vacuum actuated sensors and switches. The nut holding it on the back of the EGR stud was very difficult to get off.
View attachment 419717

The rail is all rusty, must paint it...
View attachment 419719

Sanded and masked off time for some Krylon
View attachment 419721

Hanging to dry but it is only 35 degrees in my garage, what to do...
View attachment 419723
View attachment 419725

Wife is like WTF are you doing with my oven???
View attachment 419727

Oh man it looks like brand new now
View attachment 419729

Cannot see it too good but the "rail" is reinstalled and it looks much better
View attachment 419731

I HATE MICE

It indeed took way more time than I wanted it to. Pretty much the whole weekend was spent cleaning and correcting situations. And last weekend... And half my weeknights... Eventually I will get ahead of it all.

Oh I will be removing it to clean the intercooler vanes

And just to see how it comes apart

Thanks for the tip!

I have the SVTPerformance instructions.